I have a 96 Blazer and had to replace the "3rd" stop light (The high mount set of lights mounted above the glass). I had to buy the entire unit because the bulbs are wired to the circuit board. The dealer wanted $112.00 for the unit but I got one from "GMPARTSDIRECT.COM for $65.00
It depends what is wrong with it.
recall contact Chevrolet dealer
will a 245x75x15 fix a 2001 chevy blazer 2dr
Fix the cause of the codes, and clear the codes with a scanner or by unhooking the battery.
trying to fix simular problem
Check the fuse, check the bulbs and check the brake light switch, it should be one of those.
Check the fuse, check the bulbs and check the brake light switch, in that order.
Yes you can but that is a temporary fix. Some stop leak brands do more damage than good by plugging up everything else like the radiator for example. I recommend "Barr's" brand stop leak if you are going to use one.
Check the bulbs they are double filamented -smaller for brake lights larger for tailights Check the fuse Check the stop light switch usually located at the upper end of the brake pedal under dash area
That requires an ENGINE SCANNER to do that. But you will first need to fix what is wrong are the light will come back on. Have engine scanned.
everything appears okay - what could be the cause and how do i fix
It would depend on what is wrong with it.
some cars abs light comes on if your third brake light is not working. check and see if a wire is broken, ect.
Check the fuses, check the bulbs but first, be sure the dash light dimmer control is not turned off.
Replace bulbs Check the fuse Check the stop light switch
Possible bad stop light switch located near the brake pedal.
Came up to a stop light and when the light changed the car would not move.
Replace and bleed line
fix vapor lock on 1998 chevy s10 2.2 liter 4 cylinder
Beeping or blinking lights indicate a problem within a car. In order to get the lights to stop, a person must fix the problem.
you do not fix the light. you fix what ever caused the light to come on. so the lenght of time depends on the cause for the light to go on on the first place.
It is the actuator, look this up on Blazer forum, someone will tell you step by step how to fix it!! You will have to loosen the inner panel and get your hand in there and find the proper linkage to pull on.
fix your kebc on belt hosing or bypass it
You will need a engine scanner to do that. But if you did not fix the problem that made it come on then it will just come back on. You need to have engine scaned to see whats wrong.
Well first of all you need to specify what the problem with it is