answersLogoWhite

0


Best Answer

get a 12 volt test light from somewhere and check to see if you have power at your turn signal lights by removing lenses or bulbs( depending on application) and probe bulb holder for power. if you don't have any power at the bulb holder with the turn signal switch turned on for the side of car you are testing for power, you have either a break in your wiring or your turn signal switch is not making contact to complete the electrical circuit to send power to your turn signals. Before starting this procedure, take the time to read a service manual for your car in the electrical section, you will find many helpful tips on how to diagnose your problem by following their troubleshooting flow charts. ----JT---

User Avatar

Wiki User

โˆ™ 2006-08-24 05:01:37
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you fix turn signals on 1994 geo prizm i already put in new flasher fuse bulbs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Your signals dont work on a Geo Prizm 1995 what could it be?

bad bulbs


Where is the turn signal flasher relay located on a 1997 Geo Prizm?

The turn signal flasher relay switch is located beneath the drivers side dashboard. The turn signal flasher relay switch will be to the left of the brake pedal.


How do you replace bulbs on a 1996 Geo Prizm?

The bulb and harness twist off the back of the lens. The lens is a separate unit.


What is wrong if the headlights and high beams do not work on a 1994 Geo Metro but the turn signals do?

First thing to do is check your fuses. Look under the hood for a fuse box there. It will be labeled on top and should show you what fuse is for what item. My 93 Prizm has this and there are two fuses for the headlights. Check them first. If they're okay, you need to check the plug-ins to the bulbs themselves. If they're okay, check the bulbs and if they're okay, check the wiring harness for any breaks. Your turn signals don't have a thing to do with your headlights.


What can be done to get the dash light working on a 2000 Chevy Prizm?

For lights behind the speedometer/tach warning light area, you have to take the screws out of the panel and then guide it out enough that you can twist it sideways and pull out the burned out bulbs. Replace with bulbs #194 and I would use the Long Life version of the bulbs.


Why does geo prizm engine cut out when turning left?

check the fuel pump sceen in the tank . I already experienced this problem .


How do you replace the rear speakers in a 1993 Geo Prizm?

Just scroll through the questions on this site. It's been answered already.


When was Geo Prizm created?

Geo Prizm was created in 1989.


How do you change the license plate bulb on a 2001 Geo Prizm?

The light is held by clips. You can remove the housing by using your fingers or a small screw driver. Once you have the housing out, you should be able to easily replace the light bulbs. The bulbs come in pairs and cost about 5 bucks.


How do you get a 1991 Geo prizm into overdrive?

My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive


How do you remove the driver's side tail light assembly to access the bulbs on 1993 Geo Prizm?

Open your trunk. Remove the black pins in the felt liner and then you'll see the tail light assembly. You can access the bulbs without removing the assembly. Just get the felt liner out of the way.


What is a Geo Prizm compatible with?

Geo Prizm is compatible with the Toyota Corolla.

People also asked