Starters and Ignition Systems
Oldsmobile Alero
Grand Prix SE

How do you get a 1999 Olds Alero to start after replacing the ignition switch and key and bypass security code?


Top Answer
User Avatar
Wiki User
2007-09-21 16:32:23
2007-09-21 16:32:23

I don't think you can bypass them.

User Avatar

Related Questions

To bypass the ignition switch on a 1994 Chevy Astro, simply attach a wire to the ignition switch where it makes contact after the key is turned on. Run the wire to the push button and install at the lower part of the ignition switch to send power to the starter. Ê

Usually by removing the old switch and replacing with a new switch.

please give instructions on replacing the ignition switch on my 99 Malibu

lost key for atv need to know how to install ignition

Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?

Yes, you can. However I would not recommend it.

Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.

how do you get ignition switch out of steering column in 2000 catera?

Steps to replacing 1997 Mercedes-Benz C280 ignition switch?

It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.

Are you using an original key, or a replacement that has the proper security computer chip located in the fat plastic part of the key? If not, the car's security system will keep the ignition locked and will not allow you to turn the ignition switch. ALSO: some earlier models of Focus had ignition switches that were a problem. If you ARE using the correct key and can't turn the switch to start the car anymore, the ignition switch may have to be replaced.

you must check the brake pedal release switch it will have probably failed at the same time as the ignition switch was replace by coincidence or you bumped the wire off replacing the ignition switch

We are replacing the ignition switch on a 1976 ford F150 Need some help - give us directions

Get a repair manual for your truck, because you will need to cut the wires out of the ignition switch, and bypass the alarm.

Why is the charger controller on a 49cc change from a four wire to a three wire?

2002 mazda ,,gauges are still working after taking out key..any ideas

Disabling the keyless ignition security lock on a 2007 Saturn can be done by programming the security locks. Turn the ignition to run, without actually starting the engine, and press the unlock switch for eight seconds.

There is no kill switch. It's passlock, a passive security system that works with your radio, ignition, and dashboard. There is a procedure to bypass passlock, but it's complicated. To get your car started, just leave the ignition on for 10 minuites and the security light will go out, and you can start your car. If you've recently changed a radio, dashboard, or installed a remote starter, you probably affected passlock.

I had the same problem. I took it to a mechanic and they told me it was the ignition switch.

No such switch. Just put the key in the ignition and turn it on, or unlock with the remote.

You mean, I think, ignition switch module, which is the location of the ignition switch.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.