On the back of the caliper there should be a bolt its a 14mm you take it out and inside there is a bolt also its Allen key you use and Allen key and retract the caliper. it works on all 626 from 1994 till 2002
There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.
If it is the front brake use a "C" clamp to retract piston If it is the rear and the parking brake is used by this caliper piston is threaded and a special tool (not expensive) available at Sears or auto parts to "screw" piston into caliper body
Clockwise to retract piston into caliper body
You cant, it needs a 'C' clamp.
Rotor "Out of Round" when rotating "High" spot will cause piston to retract into caliper body
Rotor "Out of Round" when rotating "High" spot will cause piston to retract into caliper body
Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body If parking brake is used on this caliper piston is threaded and a special tool (not expensive) is required to thread piston into caliper body
The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper. The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper.
Compressing the rear brake caliper piston on a 2008 Chrysler Town and Country requires a special tool that pushes in and turns the piston at the same time.
Proper Torx bit or wrench for caliper C-Clamp to retract piston to get it off the disc
this should be the same caliper as the cronos, mx 6 and eunos 500. Behind the caliper there should be two 14mm bolt look for the one directly behind that piston,remove that bolt and usin a 4mm Allen key in that space you could adjust that piston. that should work!
a special scanner called a v.a.g. has to be used to retract the electronic e brake system, and will also retract caliper piston..DO NOT TRY WITH OUT TOOL !!!!!