If you are using a jet pump then you have a loose connection somewhere. Jet pumps in general are notorious for being picky about tiny air leaks. You literally need to go over every single connector and heat the pipe as you re-connect it, to get an excellent seal.
If you have a deep well submersible, then you possibly have a hole or leak in the downpipe in the well. This can be a really complex issue and if you are not very familiar with well problems, I'd strongly suggest calling a well technician. NOT a plumber, they know little about wells in general.
There is no air in groundwater. If there is air in your well water lines then either your pump or foot valve is at static water level and sometimes sucks air, - or there is a small leak in the pipe which will both admit air and leak water, depending on pressure. If you are using a Jet-pump at a well shed, air leaks are quite common. Most people do not know how to properly attach water pipes to fittings. It is also possible that the down pipe into the well has vertical cracks. This too is common certain kinds of pipe.
this is most common down towards the bottom of the well. the pipe well casing could have even just a pin hole from corrosion to small for water to get through but just enough for air to get in. this would when the water flows it would cause a vacuum to come into the pipe allowing air into it. The result of this would give you a milky color water. To test if it is air just fill a glass or vial or any container really and put water in it and let it sit. if the milky color doesn't disappear then it is not air. To fix you would most likely have to replace the well casing or the pipes attached to the pump.
well it does but not that bad as when you make paper because to make paper that causes air pollution and water pollution.
To saturate the air with water vapor, you can lower the temperature to it's dew point, and leave out water to be evaporated.
Could be a number or reasons - is your pump near 'static' water level, so sucking air sometimes. -Is there a leak or break in the pipe from well to tank. -You need to get a well technician ( NOT plumber ) to check your system.
In a well system, water is propelled by air pressure.
You will need to connect the air. Professor to the water pump. The air going into the well will force the water upward.
no, water is actually like air except its ...well...water
well we can say that air dissolves in water as marine animals need O2 for breathing.
The dragon fish breaths in air from the water so keep the tank well filtered, or have air bubbles.
Yes ,it can breath from water as well as from air.
Yes because if the container has a whole in it the air well make the water squezze out of the whole
If you mean a well tank, the water is forced in by the pump. The residual air pressure pushes the water out to the faucets.
There is no air in groundwater. If there is air in your well water lines then either your pump or foot valve is at static water level and sometimes sucks air, - or there is a small leak in the pipe which will both admit air and leak water, depending on pressure. If you are using a Jet-pump at a well shed, air leaks are quite common. Most people do not know how to properly attach water pipes to fittings. It is also possible that the down pipe into the well has vertical cracks. This too is common certain kinds of pipe.
Yes ,it can breath from water as well as from air.
natural gas?
No, pumps water only. A submersible pump can only pump what it is submerged in and since there is no air under water......