to be able to take off the door panel you have to take out the screw for the interior door handle. then take off the black panel by the mirror on the inside.next you must find the plastic screws that hold in the door panel with a Phillips head screwdriver. after that you must take off the switch, generally for me i can pop it out with a flat head, then take off the wire to it. after all of that it should pop loose to get around the lock you have to pull the door panel over it and it should come off clean.
Add your answer:
Related Questions
How do you remove the evaporator in 2002 Toyota corolla?
How i remove eveporator unit from toyota corolla 2002
How do you remove the center console on 2001 Toyota Corolla?
how do you remove a center console on a 2001 toyota corolla
How do you remove CV axle from automatic 92 Toyota Corolla?
how do u remove cv axle driverside 1991 toyota corolla
How do you replace the headlight on the drivers side of a 1994 Toyota corolla?
Open the hood of the engine compartment to your 1994 Toyota Corolla. Remove the wiring harness from the headlight. Remove the headlight retraining bolts from the headlight assembly. Reverse the process to install the new headlight.
How do you remove the alternator on a 2009 Toyota Corolla?
No
How do you remove the heater core on a 1997 Toyota Corolla?
How do you remove the heater core on a 1997 Toyata Corolla?
How do you remove alternator Toyota Corolla?
which pully do i remove tension to remove the alternator?
What is the location of the power window relay on a 1991 Corolla?
The 1991 Toyota Corolla power window relay switch is located inside of the drivers side door. You will need to remove the drivers side door panel in order to access the relay switch.
How do you remove the back seat of a 1998 Toyota Corolla?
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
How do you remove the front bumper from a Toyota Corolla?
The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.
Can you remove the antenna of a 2003 Toyota Corolla?
It screws right out
How do you remove dash trim on 1993 to Toyota corolla?
Carefully
How do you remove rear seat of Toyota Corolla?
The type of the rear seat of the Toyota Corolla will determine how you will remove it. For instance, for a folding seat, all that you will need to do is to lower the seat to gain access.
Are the starters in a Toyota Corolla the same as a Toyota matrix?
Starter of toyota corolla and matrix is not the same. The best thing you do if you change your starter by yourself is to remove and compare to the new starter.
Replace front wheel bearings on a 1989 Toyota Corolla?
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
How do you remove and replace the fan belt on a 2002 Toyota Corolla?
it is no suh a thing is fan belt on 2002 corolla
How do you remove the tail light on a '97 Toyota Corolla DX?
remove the screws which are hard to get to.
How do you remove fuel lift pump in a Toyota corolla?
you put cat litter on it
How do you remove the stereo in a 1988 Toyota Corolla?
Remove the plastic panel, remove the bolts, disconnect the wires from the back of the stereo and remove
How do you remove the radio on 2006 Toyota Corolla S?
I have created a PDF w/pics that details each step of removing the factory radio from a 2006 Corolla. The PDF can be downloaded from the link below. http://drop.io/dantes411/asset/how-to-remove-the-factory-car-radio-from-a-2006-toyota-corolla
How do you remove the rear cup holder on a 1998 Corolla LE?
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
How do you remove radio in 1995 Toyota Corolla?
To remove the radio in a 1995 Toyota Corolla, first pry the radio frame from the dashboard using a flat tool like a screwdriver. Then, press in on the pins at each side of the radio and slide it out of the dashboard. Remove the wires from the back of the radio.
How to bypass ac low pressure switch on Toyota Corolla?
You can bypass the AC low pressure switch, on your Toyota Corolla, by removing the switch. You can remove the wiring to the switch and leave the switch and place.
How do you remove the radio in a 1999 Toyota Corolla?
Try this web site http://www.installdr.com/InstallDocs/Toyota/PDF/869001.pdf
What size wrench is needed to remove a caliper bolt on a 1999 Toyota Corolla?
14 mm
