answersLogoWhite

0


Best Answer
Copy

First you have to remove the glove box. Then you unpulg the wire from the blower motor. Remove the rubber hose between the motor and blower housing. Next disconnect the cable from the case assembly. Take out the 3 blower case mounting screws and lower the case. Then you take out the 3 screws holding the motor in and lift it out. If you're going to put a new one in, you'll have to take the wheel off your old one and re-use it. If it's busted, you might be able to get a new one at Autozone or Advance.

User Avatar

Wiki User

โˆ™ 2015-07-15 20:57:25
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you get the blower motor out of a 1992 Geo Metro so that you can replace it?
Write your answer...
Submit

Related Questions

Where on a 1992 Geo Metro would a blower motor be locacated?

The Blower is mounted under the passenger side glove box high on the firewall


How do you replace blower motor on a 1992 Buick Century with the power steering reservoir and pump in the way?

You may have to vmove them to get at it


How long does it take to replace blower motor 1992 Chevy truck?

About 15 mins. That's a easy job.


Where is the blower motor on a 1992 buick regal gran sport?

The blower motor on a 1992 is located under the hood. It is on the firewall on the passenger side.


Replace blower motor on 1992 Mercedes 300e?

under the hood.. by the windshield wipers.. it blows in .. doesn't suck through.


Where is the blower motor resistor located in a 1992 Honda accord?

It is located on the blower motor housing and is white in color. You have to take the blower motor assembly out as far as I know to get to it.


Do you need to take off the dash to replace blower motor in a 92 town car?

( No ) The blower motor is in the engine compartment . It is near the firewall towards the passenger side of the engine compartment in a 1992 Lincoln Town Car


How do you change a blower motor on a 1992 Toyota Camry?

The blower motor is on the passenger side underneath the dash. Its not hard to get too. It has 3 or 4 screws and it takes a little manipulation to get it out but its a simple job. Took me about 30min. to remove and replace it.


How can you remove and replace a blower motor on a 1992 Lincoln Town Car without having to remove the antifreeze reservoir?

If the reservoir is blocking the way, then it will have to be removed.


Where is the blower control resistor located on a 1992 Ford Explorer?

under the blower motor housing. to the right


Why does heater blower on 1992 s10 run on high only?

Probably the blower motor resistor is shot.


Does a 1992 dodge ram 350 van have a relay for the blower motor?

Yes. First check to see that you have 12 volts to the blower motor. If yes, blower motor has probably failed. If no, it may be the blower motor relay or there is a speed control resister pack causing your problem.


Where is resister for low and medium blower speed 1992 1500 Chevy?

usually mounted on or next to blower motor


Can you use the hatchback from a 1992 Geo Metro to replace the hatchback on a 1994 Geo Metro?

it should be able to


Where is the blower motor on a 1992 Ford Explorer 4 dr 4.0L 6-cylinder?

The blower motor is on the right side of the engine compartment on the firewall.


Where is the blower motor resister located on a 1992 explorer?

Looking at the picture in my Haynes repair manual it looks like the blower motor resistor is in the engine compartment mounted just to the right of your blower motor when looking from the front of the Explorer - Helpfull


Why does your 1992 f150 heater motor only work on high?

Most likely and bad blower motor resistor.


Why doesn't your blower motor work on a 1992 Oldsmobile Delta 88?

also check the AC clutch check for blown fuse... a possible bad blower motor relay


How do you replace a blower motor on a 1992 Chevy S-10 Blazer?

The blower motor is located on the firewall on the passenger side. There are 6 bolts that must be removed to allow the blower to be pulled from the housing. Once the motor is removed you will remove the fan with by loosening the Allen screw. The motor can now be unplugged and ready for placing back into the blower housing. Re attach the blower wheel wet the assemly back into the housing and hold in positio0n iwth the 6 mounting screws you removed earlier. This is a very easy part replacement.


Is there a sensor on the blower of a 1992 metro have replaced switch on dash but still only work on high speeds?

THERE IS A RESISTOR NEXT TO THE BLOWER MOTOR IN THE SAME HOUSING, IT IS EITHER A CLIP IN OR A SCREW IN UNIT,RESISTORS ARE GENERALY FOR THE LOWER SPEEDS AND THEN THERE IS A HIGH SPEED FUSE/RELAY SETUP. JOHN


Will a Geo Metro motor fit a 1992 geo storm?

sue in da house


Where is the blower motor located on a 1992 GMC Safari Van?

The motor will be located under the hood at the far right corner.


Where is blower motor resistor on 1992 Carina?

The blower resistor is located behind the dashboard. It is found behind the heater near the center of the vehicle.


How do you replace the blower motor in a 1992 Chevy Corsica?

Generally, getting access from under the hood ,you remove the 6 screws holding the motor in place, then remove the ground and hot wire and finally the vent tube. Reverse procedure.


Why does the blower motor of a 1992 Buick La Saber stay on after the car has been turned of?

Overheating at the Fan Switch merges contacts inside. Replace the switch and the problem will go away.