Oldsmobile Alero
Honda Civic LX
1995-2005 Chevy Cavaliers

How do you get the dash apart to install Cd player in a 1998 Cavalier?

567

Top Answer
User Avatar
Wiki User
Answered
2009-07-27 19:38:14
2009-07-27 19:38:14

i have a 1998 2 door cavalier, 5spd. i never took the dash apart. to my remembrance all i did was remove two screws on the underside right above where the front change dish is and pop the bottom out a little. once the cover is popped off you'll see a bunch of hex screws holding the factory deck in place. in my vehicle i had a radio and no tape deck, remove them and the factory deck should slide out. advise getting a wiring harness, GM's wiring is shoddy. my first mistake was clipping all the wires and hard-wiring my first cd-player. good luck :)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


NEED help is there a diagram with the bolts in the backseat of a 1998 chevy cavalier?

Separate the tranny and engine...It's in there.

The drivebelt routing decal on the radiator shroud to help during drivebelt install

replace the starter on a 1998 Chevrolet cavalier

Cavalier Telephone was created in 1998.

The starter for a 1998 Cavalier is mounted on the side of the engine. It is at the rear, near the bottom.

I am looking for the Thermal fusible link for the headlights on a 1998 Chevrolet Cavalier

Begin by removing the traveling arm retaining bolt from your 1998 Chevrolet Cavalier wiper motor. Remove the wiper motor retaining bolts. Remove the wiper motor wiring harness. Reverse the process to install your new wiper motor.

how do reset a 1998 chevey cavalier antitheft system if it want start and the anti theft light is on

Approximately 85 percent of the parts of the 1998 Chevrolet Cavalier and the 1998 Pontiac sun fire are interchangeable. Most of the parts that are not interchangeable are in the passenger compartment.

Never as the 1998 Chevrolet Cavalier does not have a belt, it has a chain that should last the life of the engine.

To change the shift linkage in an 1998 automatic Chevy Cavalier the shift linkage needs to be removed from the transmission and pulled from the cabin. The job requires removing the floor console to access the cable. After doing the so the cable can be snaked from inside the cabin, the install is the reverse of the removal.

The 98 Cavalier 2.4 is a NON interference engine.

How do you install a radiator in a 1998 ford contour?"

The 1998 Cavalier does have a PCV valve. The valve is in the side of the valve cover, held in by a metal ring.

On a 1998 Cavalier, the IAT sensor is located in the hose connecting the air cleaner to the throttle body. The IAT is a two-wire sensor.

How do you replace a turn signal bulb in a 1998 cavalier

No, I have a 1998 Cavalier and it does not have a cabin filter. You can take off the 3 bolts off the heater blower and remove any leaves or debris.

How do you install projector headlights on a 1998 Chevrolet corvette

Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

Both the front and rear bearings on a 1998 Cavalier are contained in the hub assembly. The rear hub is attached with four bolts, and the front with three.

1998 Chevy cavalier with power windows are driver side window is down how can i jump the motor to raise it up thank you for your help

how to install distrutor cap and rotors in a 1998 chevy astror van


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.