1995-1999 Dodge & Plymouth Neons

How do you get the front door panel off to replace the speakers in a 2001 dodge neon SE and also how do you install the speaker once the door panel is off?

161718

Top Answer
User Avatar
Wiki User
2006-11-10 01:21:42
2006-11-10 01:21:42

Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Pull off the door panel, unscrew the stock/old 6.5 inch speaker, disconnect the speaker wiring and connect the new speaker. Screw the speaker in the hole in the door and replace the door panel.

User Avatar

Which speakers are you trying to replace? Front or rear?

User Avatar

Dodge spirit and Plymouth Acclaims use 5 1/4" speakers in front and rear doors. The covers pry off if done gently. The have plastic tabs holding them on. They get brittle so be careful. Just unscrew and install new speakers and snap on the covers. They sell kits a Walmart and other stores if needed for the speakers. I'm getting ready to replace the door speakers in my 94 Dodge Spirit.

User Avatar

dodge factory speaker sizes are 6"x9"

User Avatar

5.25" - I have one of these cars and want to replace the front speakers too. The backs are 5x7s.

User Avatar

infinity speakers have the amp on the speaker

User Avatar

you get the speaker and smash the neon up then you are done OK !!

User Avatar

The two front speakers are 6 1/2 and the rear speakers are 6x9s.

User Avatar

The front speakers are 6x9" and the rear speakers are 5.25".

User Avatar

the door speakers are 6.5 and the rear are 6x9

User Avatar

There is no fuse for the speakers, only the radio.

User Avatar

All 4 speakers are 6x9's

User Avatar

I helped a friend that owns a 2001 dodge ram ext. cab which im almost sure is the only option for that year other than a reg. cab. His had the infinity speaker system in it and every speaker has a amp built into the back of it, im not sure how it works but i know that that is where it is, and if you are looking to replace your speakers with non- OEM speakers, you need to run new wires to the speakers because of how the amp/speakers are set up.

User Avatar

Take the door panels screw the screws out the speaker pull the plug off the speaker put the new one redoing everything you did to take it out

User Avatar

Small screwsriver pop the metal speaker covers off..easy access to speakers from there

User Avatar

Remove the switches and a couple screws that hold the door panel on. then pry the push in door clips that hold the door panel in place out. take the screws out of the old speaker and cut off the pigtail attached to it. solder and shrink wrap or crimp on the new wire connectors that came with the speakers and re-install.

User Avatar

The front speakers, in your 2008 Dodge avenger, will measure four inches by six inches. The back speakers will measure six inches by eight inches.

User Avatar

Rip the old ones out. Then replace with new ones.

User Avatar

Carefully remove the A pillar cover.. Then pop out the speaker screen..

User Avatar

2002 dodge ram 1500 has a single 3.25 speaker in the center of the dash

User Avatar

The front and back speakers are 6x9, there are also speaker holes in the front dash on the left and right. The dash speaker holes are small, like 3 1/2 or 4 inch.

User Avatar

The dash speakers on the left and right are 3 1/2" round speakers. I have no idea how big the center channel dash speaker is.

User Avatar

you hump them until they start to get dents. then replace them they are discusting now.

User Avatar

If you have the 4 speaker base system, both the door and the rear speakers should be 6x9. The 6 speaker "premium" system should add 3.5in in the dash.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.