answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2007-08-26 03:28:14

Answer

I used an AC line tool which fits in the fuel line locks, i think it's a 5/8, not sure of it but you can get it from your local auto parts store, insert it along the fuel line and pull gently lines apart, put a rag to catch fuel spilling and de-pressurize system prior to attempting. Make sure to buy the plastic tool since the metal one might break or deform the fuel fittings.Good luck!

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

How do you change the in line fuel filter on a 1997 Ford Expedition Eddie Bauer with a 5.4 Triton Motor?

The filter is located in the frame rail on the driver side. It takes a special tool to get the lines to release. Any auto parts store carries them. You simply insert it in the end between the line and the filter then pull the line away.


How to change a transmission filter on a 2003 ford explorer?

follow the lines to the front you will see the filter by the radiator just like my 03 xlt


How do you change the fuel filter on a 2002 ford explorer xlt?

first need spl.tool to releace fuel lines from filter. very ez when you get tool.


How do you replace the fuel filter located on a 2003 Ford Explorer Sport Trac?

Well the lines from the tank to the filter require a special tool you can buy at Auto Zone for about $6.


How do you replace a fuel filter on an Infiniti qx4?

follow fuel lines to filter. remove lines from filter and fit lines to new filter.


How do you change the fuel filter on a 2000 Infiniti I30?

trace fuel lines to filter, disconnect lines from filter, fit lines to new filter


How do you replace a fuel filter on the Infiniti G20?

separate the lines from the filter and fit the lines onto the new filter. just trace the fuel lines to find the filter


Where are vacuum lines on Ford Explorer 2002?

The 2002 Explorer has several vacuum lines. There are many lines in the engine compartment as well as under the dash.


Find the fuel filter on a 1997 sonoma?

Follow the fuel lines from the fuel pump toward the engine. You will find the filter.Follow the fuel lines from the fuel pump toward the engine. You will find the filter.


How do you change fuel filter on a 2002 Ford Explorer xls?

Hi I am EfRain , The fuel filter Is Located on a ford explorer 2002 xls on the paseger side, Theres a panel to remove two 13mm bolts.Ok You Need a swivel socket.after removing the panel you would need a 10mm socket to disconnect the frame bracket for the filter. make sure you put the correct Lines on the filter. Look at the size diference, 2 sides and on the other line towards the engine is one Line. push the clips out and pull off the two Lines. Other side you need a special disconnect tool. put it all together.


How do you replace the fuel filter located on a 2001 Ford Expedition Eddie Bauer?

You need a special tool to remove the filter. A fuel line disconnect tool which you can get at an auto parts store. Make sure you bleed off the fuel system pressure before you begin. One way is to do this by unplugging the electrical connection from the inertia switch (located behind the passenger side kick panel) Start the engine and let it run til it quits. Shouldn't take more than a few second. This should bleed off the pressure. Now you can use your special tool and remove the lines from the filter.


How do you replace the fuel filter on a Chevy Blazer?

Depending on the year, the blazers fuel filter is most likely on the frame. While covering the connection with a rag, loosen the fuel lines from the filter. Remove the filter and replace, then reconnect the lines.


How do you change fuel filter craftsman mower?

Remove the fuel lines from both Ann's of the fuel filter. The lines can be removed by loosening the clamps. Reverse the process to install the new fuel filter.


Where is the fuel filter on a 2002 ford explorer sport?

It's located under the driver side attached to the Frame just in front of the O2 Sensor , special tools are required to remove fuel lines


How do you replace the fuel filter located on a 1986 Buick LeSabre?

Just squeez the white colored plastic pieces and pull the lines away from the filter. Warning Fuell will leak or spray from lines but, will stop shortly. than just sanp the lines onto the new filter


How do you replace the fuel filter on 2002 for explorer?

# The fuel filter is located under the vehicle on the right side,in front of the gas tank # Relieve the fuel system pressure,then disconnect the negative battery cable # If necessary raise the vehicle and support it securely.Remove the filter heat and rock shield # Inspect the fittings at both ends of the filter to see if they're clean.If more thena light coating of dust is present clean before proceeding # Release the clips holding the fuel lines to the filter # Detach the fuel hoses,one at a time,from the filter.Be prepared for fuel spillage # After the lines are detached,check the fittings for damage and distortion.If they are damaged in any way during removal,new ones must be used when the lines are reattached to the new filter. # Remove the fuel filter from the mounting bracket,while noting the direction the fuel filter is installed.


What is the correct plumbing for the fuel lines. Tank to filter to pump 1986 bronco 302 EFI. There are 2 lines into the filter and 2 lines out which is which?

They are two different sizes and should be color coded


How do you change a fuel filter on a 97 infinity j30?

The fuel filter is on the passenger side of the engine compartment, near the rear. Remove the filter from the holder, and pull it up high enough to remove the fuel lines. Reconnect the fuel lines to the new filter.


Where is the fuel filter located on a 1990 Mercury Sable?

You will need to jack up the RR corner of the vehicle to reach it. The fuel filter is fastened with a big clamp to the right side frame rail, close to the fuel tank, just ahead of the RR wheel. Use a small flat screwdriver to remove the two plastic clips from the lines attached to the filter. Be careful, the lines are under pressure, and there will be fuel that will spray out as you unplug the lines from the filter. Use a flat screwdriver to loosen the clamo from the body of the filter and then you can remove and replace the filter. Install the new plastic line clips that are in the box with the filter into the lines and then plug the lines onto the filter until you hear them click in place.


How do you replace the fuel filter on a 1991 Mercury Sable?

You will need to jack up the RR corner of the vehicle to reach it. The fuel filter is fastened with a big clamp to the right side frame rail, close to the fuel tank, just ahead of the RR wheel. Use a small flat screwdriver to remove the two plastic clips from the lines attached to the filter. Be careful, the lines are under pressure, and there will be fuel that will spray out as you unplug the lines from the filter. Use a flat screwdriver to loosen the clamo from the body of the filter and then you can remove and replace the filter. Install the new plastic line clips that are in the box with the filter into the lines and then plug the lines onto the filter until you hear them click in place.


How do you change the fuel filter in a 2007 mustang gt?

Before you disconnect the fuel filter you MUST de-pressurize your fuel lines, you can do this by taking off the cap on the fuel rail and depress the valve slowly, then you can remove the filter. There is a set of quick disconnect tools available at all auto parts stores. You simply slide the tool onto the line at the filter and press it into the pressure fittings on your fuel lines. This will release the filter from the lines. To re-install just push the new filter into the lines( making sure flow is in the right direction) and push retainer clips back on the lines.. NOTE.. the retainer clips have to be removed before you can pull off the old filter.


How do you replace a fuel filter in 1996 Buick Skylark?

Locate the fuel filter on the 1996 Skylark frame rail. While covering the fitting with a rag, loosen the fuel lines, and remove the filter. Take the filter off, and connect the lines to the new filter, keeping the flow arrow towards the front of the car.


Does a 1998 Johnson hp 115 have a fuel filter?

Yes, follow the fuel lines and you will find the filter.


How do you change a 94 explorer fuel filter?

To the best of my knowledge, it's on the frame, drivers side, pretty much right under the drivers seat. It should have a worm clamp on it, loosen that with a screw driver. There should be a clip on each side of the filter holding the lines in. Use your screw driver to pry these off. The new filter SHOULD come with new clips. I try to save mine anyway. After getting the clips loose, place a rag around the lines where they meet the filter. There will be pressure in the line. Pull the line off, catching the gas in the rag, not in your face or eyes. Done that. Both lines should pull off freely. reverse the process using the new filter. Good luck.


What is wrong when fuel leaks out after filter replacement?

The filter does not have a good seal. If it is a pressurized system remove the filter clean the lines and filter clips and reinstall. If it still leaks then you may have a bad filter.


Still have questions?