Car Stereos and Speakers
Chevy Silverado
Chevy S-10

How do you get the trim around the rear speakers off of a 97 S-10 ext cab?

91011

Top Answer
User Avatar
Wiki User
Answered
2007-07-28 06:28:31
2007-07-28 06:28:31

i had the same problem... all you have to do is unscrew all screws... two in bottom one in the hanger piece. you also have to take off your seat belt clip on the trim.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


4x6" in the dash and 4x10" in the rear

doors are 6.5 rear speakers are 4 by 9

You will have to remove all trim that surrounds the speaker enclosure. Then remove the panel that houses the speaker. The speaker is removed from the rear side of this panel.

my 1990 s10 has 6 and a half in the front and 6 by 8 in the rear.

4x6 in the dash and 6x9 in the rear

Front - 4x6 Rear - 4x10 Hope this helps! Nick Quisenberry

4x6" speakers in the dash. 6 1/2" round speakers in the doors and 3x10" or 3x12" in rear panels if ext cab

did a 1984 Chevrolet s10 come with door speakers

; In-dash stereo : 5-13/32" depth ; Front speakers : Dash: 4x6" : Front Door: 6-1/2" factory speaker note ; Far rear speakers : Rear Pillar: 4x10"

The 1988 Chevrolet Blazer front speakers measure three inches by four inches. The rear speakers measure four inches by five inches.

What size are the speakers in a 1992 standard cab Chevy S10?

Durango was a trim package on the S10 and S10 Blazer in the early/mid 90's

This is not easy unless you have seen it done and know what to do when. TAke it to the trim shop.

On a zr2 model you will need around 10" in the front, 9" in rear. For regular model s10 4x4 you will need about 13" in the front and 12" in rear.

Fuel trim malfunction, bank 1.

If that S10 is a 4+2, it is rear wheel drive.

Is the S10 a 4x4?If not, measure everything and if it is correct Go for it

it should bolt right up

The door speakers are 6.5" and the dash speaker size is 4."

4x6 dash 5 1/2 front door 6 3/4 rear door cargo if equipped has 6x9

The rear bumper of a 98 Chevy S10 can be removed by disconnecting the rear wiring harness and taking out the retaining bolts. The bumper can then be removed from the frame and pulled from the vehicle.

Chevy S10 pickup 4cly 2.5 engine,how to change rear oilseal

I know that in my 1995 s-10 ext. cab I have: 4x6 on the dash61/2 in the doors4x10 in the rear pillars Charlie in N.Y.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.