sensor assy vacuum
I believe it is part of the wheel bearing/ hub assy.
On the drivers side of the engine in front of the brake booster. Is a black looking box with several Vacuum hoses.
It is a vacuum release when the car is shifted into drive or reverse. Also has a manual release lever on the e- brake pedal assy. Good luck
Check this one out http://cgi.ebay.com/ebaymotors/Toyota-Camry-Dome-Light-Sunroof-Switch-Switches-97-01_W0QQcmdZViewItemQQhashZitem3ca6559996QQitemZ260488665494QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories
On/by the Throttle body, should read "sensor assy map"
on the air filter housing assy
the sensor is part of the fuel pump assy and comes out through a hole underneath the matting in the trunk.... remove the cover and remove lines from assy and then remove assy from tank.....make sure to relieve pressure from fuel lines before you remove lines due to residual pressure in the lines...
There is a fuel temp sensor mounted on a bracket inside the tank and a low fuel sensor on the fuel pickup assy...
Take the light assy off of the car and turn the bulbs counterclockwise to remove the blubs
Before buying any sensor you need to make sure that it fits your car. You need to locate the sensor and write down its number only after that buy another one.
To find the crankshaft sensor remove the fan assy from the radiator and the exhaust manafold heat shield then just below to the right end of the manafold you will find the wire to the sensor. To remove it you will need a #30 Torx tool. The camshaft seneor is located almost straight above at the end of the cam.