2004 Ford Expedition Eddie Bauer edition flapper motor is bad how do i get to it to repair the part
My 03 had the the same problem. Ford ended up having to replace the rear blower motor...it was still under warranty, thank god.If the air still blows then the blower motor is working. The sound you are hearing is a stripped gear on the flapper motor that operates the blend door. It causes the door to continually close and open. The replacement part costs about $35 from the dealer and is easy to replace once you get all the fascia parts off.
One can purchase a blower motor resistor either in car part shops, like Autozone. Alternatively, one can try looking in eBay for cheaper blower motor resistors.
The blower motor speed resistor is burned out. The resistor is located close to the blower motor and is easy to change. Your local auto parts store will have that part for you.
You will need to replace the blower motor control unit located inside the blower motor housing, this part is not the same as the part on standard explorers, it is not the same blower motor resistor.
Swap the relay with a known good one, many of the relays are of the same part number. Keep in mind that the blower motor relay only controls the high speed function. The blower motor speed resistor and the blower motor switch controls the lower speeds.
Blower Motor Resistor is bad. 20.00 part at AZ.
The blower motor speed resistor is burned out. The resistor is usually found close to the blower motor. Auto parts stores carry that part and it is easy to replace.
No such part exists
I need a blower motor and blower motor resistor for a 1999 lasabre will the regal have the same part?
You'll find the heater blower motor resistor in the heater/air conditioner compartment. This compartment is location underneath the dashboard. This is the part that allows the heater blower motor to change the fan's speed.
The cost of a blower mower depends on the model of blower one needs the part for. As of 2014 the average cost is between 115.00 and 165.00.
The blower motor resistor is a $35 part and is easy to do it yourself. It is behind the glove box and easily identified by the wires running from the blower motor over to it. For a complete "how to" come join out free enthusiasts forum at www.trailvoy.com