If it won't come out try pushing up lighlty on the shitfer ( towards radio) or to the side towards drivers seat. You should here a click and the key will turn back If this enables you to get the key out you will need to replace the shifter.
I had this problem, the stick-shift was not fully in the 'park' position try and jiggle the stick.
I would replace the ignition switch. . John In MontanaMore InformationIt also might just be your shift linkage, the cable that connects your ignition to your shifter while in Park. This is what is wrong in mine right now. You might want to try to put the car in Low then all the way back up to park. See if that helps. Ashley You have a bad starter motor with a short. You need to replace the motor
Bent shifter rod,Frayed cable,obstruction in shifting path
most new cars need brake pedal depressed in order to take the car out of park
Sounds like a bad safety lockout switch, which would be located on the brake pedal shaft under the dashboard, but I do not know it that vehicle has one.
With the ignition off set the park brake then turn the truck on and the light will be off
under the coil pack in the engine compartment. The coil pack is where the plug wires hook into it.
The way to check the transmission fluid level is you run the vehicle in park until operating temp. When operating temperature is reached then there is a plug in the transmission pan pull out just the middle of it to check fluid.
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
Put it in park , insert the ignition key into the ignition and turn the key to start it.
Babylon Park Frightspace - 1999 was released on: USA: 4 July 1999
The neutral safety switch is bad, the ignition does not recognize it is in park. Your ignition switch may be bad.