answersLogoWhite
Buick LeSabre
Ford Explorer Eddie Bauer
Ford Explorer XLT
iPhone

How do you get your lights to stop blinking on and off on your 90 Buick LeSabre?

192021

Top Answer
User Avatar
Wiki User
Answered 2005-05-23 16:20:24

If you are driving when this happens, try to locate the loose connection around the rear of head lamp. If it happens when you arn't in the vehicle when it blinks. Run don't walk to the nearest dealer for a trade in.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


They are called traffic lights or traffic signals. -------------------------------------------------------- *** 2nd Answerer Says: Some parts of the country call them stoplights (as opposed to go-lights or caution-lights) and there is a variation called "blinking lights". "Blinking lights can be blinking red in all four directions to designate a four-way stop or full-stop in two directions & cautionary slow-down (blinking yellow) the other two directions.




Beeping or blinking lights indicate a problem within a car. In order to get the lights to stop, a person must fix the problem.


One of the main causes for a 1998 Buick LeSabre to die while driving is a problem with the computer. The computer might tell the fuel pump to shut off and stop sending fuel to the motor.


hi my car is leaking from the water pump so what can i do to stop leak ? and if i need to change the water pump would you guys tell me how can i change it?my car is 1997 Buick LeSabre v6 engine


Check your fuses before anything else. Easiest and cheapest fix.



Check to see if the brake lights are working - shift interlock and stop lights are on the same circuit - check the fuses - Try turning the key to the 1st (unlock) position shift to neutral to start and then shift to Drive Check the shifter interlock switch on the brake pedal. Possible linkage problems also.



you can never stop but your eyes is closed


No, you can stop by focusing, but it is not voluntary. It's the same as breathing.


However long it takes from them to stop blinking to the time it takes them to start blinking again.


There are no bulbs, it is a panel of mini-lights. You access this from the trunk area.



first make sure hazard lights are not on.next you need to ckeck the grounds from the battery.


May have a switch going out in doorjambs-check their operation.


Yes. The only time you are not allowed to pass a school bus is if the stop sign arm is extended.


You can't. West Point pads are pure crap. Throw it away and never buy another one!



You can't. If the lights didn't stop blinking, no one would know you were stopping. Re: I gues that´s the point of the third light, because when you are stopped, no one knows, you are about to do something else, like backing to park, or that you are stooped and they need to go around you...


There is no way of stopping the Lego Harry Potter characters from blinking.



A blinking red traffic signal is treated as a stop sign. You come to a full stop at that intersection and observe the traffic in all directions before proceeding.


Under the hood of the car we found a yellow sticker with the following instructions and explanation for this "problem." To fix the blinking you need to locate a black button on the dash under the steering wheel. With the key in the ignition and in the on position press the black button to reset the system. The hazard lights should stop.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.