you have to remove the plastic cover below the window and then remove the sheet of plastic and look for the handle coming through on the other side. the door handle moves a rod up and down. it needs lube and then work it up and down.
Remove the inner door panel. There will be an arm that is or in this case is not attached to the handle. There are two rods: one upper and one lower. Pull the top rod down to unlatch the top catch and pull the lower one up to unlatch the bottom catch. Hope this works.
The hood release handle is in the glove box.
in the glove box
There is an over-centre latch under the mat in front of the middle seat, unlatch that first, then there is a yellow latch under the front passenger seat.
To repair the rear latch on the 2006 Suzuki gran Vitara keyless entry you need to first remove the latch from its position. Next, spray the latch with WD40 to loosen it and either replace it or hit it softly with a hammer until it starts to work.
Take it to the body shop. They have to open the hoods when they are wrecked.
It is a Lever handle (long instead of a knob) that has not a lock.
lollol
when you pull the hood release handle its not going back in all the way so you hot to push in the the little half moon lever in the hole where the hood latches into.
Inner Handle Rod Inner Handle Rod
Remove the tailgate trim panel. Disconnect the remote control rod from the remote control. Disconnect the negative battery terminal. Unbolt the latch and remove the remote control. Disconnect the lock knob rod from the remote control and remove the rod. Disconnect the lock cylinder rod from the lock cylinder. Unbolt the remote control and remove it from the liftgate. Remove 2 nuts that hold the outside handle and take it out of the liftgate. Installation is the reverse of the removal steps.
put a screwdriver in the latch pull the handle and apply pressure to the screw driver should pop the latch open