Auto Parts and Repairs
Car Batteries
Toyota Corolla
iPod Touch

How do you go about changing the radio on a 1988 Toyota Corolla?

272829

Top Answer
User Avatar
Wiki User
2015-07-15 19:15:41
2015-07-15 19:15:41

Disconnect the neg battery cable then take the bolts and wires loose from the back of the radio under the dash. Then pull the knobs off and remove the nuts there and work the radio out of the back of the dash.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to do ignition timing on 1988 Toyota corolla fx

User Avatar

torque specs on head gaskets 1988 toyota corolla 4A-F

User Avatar

A chain. Every Corolla since 1988 has a chain

User Avatar

It is a vacuum line diagram for a 1988 Toyota Corolla. What else would it be. :-) Just playing. You can find one [http://www.themotorbookstore.com/corolla2.html Here]

User Avatar

it is stamped on the passanger door lock

User Avatar

Yes, Toyota has no peers in relaiablity and holding value no matter the year

User Avatar

You can find fuel line routing information for your 1988 Corolla in Toyota service manuals. The Toyota service manuals can be purchased from most auto-parts stores.

User Avatar

it is in the tank follow your rear fuel lines

User Avatar

The MAP sensor is located on the engine compartment on 1988 Toyota Corolla. The MAP sensor can be purchased at any auto parts store.

User Avatar

The original tire size is 155/80R-13

User Avatar

Inside the distributor cap under the rotor.

User Avatar

My 1987 corolla fx took 11.4 to fill on a pretty empty tank.

User Avatar

Pre 1988 had four lug wheels then in 1987 (1988 model year) Corolla went to front wheel drive and 5 (five) lug wheels. All pre 1988 are the same, and all post 1988 same

User Avatar

Flashers are normally located under the dash by the steering wheel near the firewall.

User Avatar

In the back of the engine one bolt is hidden under the air box

User Avatar

hey, I just bought a Toyota Corolla 1988, and the guy i bought it from said he had the timing belt done but he does not know when it needs to be done again. And I just want to have a check on it exept that I can not find it....please help. :P or email me @ justinridgway4@hotmail.com thanks

User Avatar

if you have the correct tools and professional help it should work.

User Avatar

if your engine is a 4ac then its a mechanical fuel pump on the cylinder head (intake side)

User Avatar

Remove the plastic panel, remove the bolts, disconnect the wires from the back of the stereo and remove

User Avatar

Please explain in detail what the brake problem is. This will help us help you.

User Avatar

The 1988 Toyota Corolla (excluding the FX16) takes 19" drivers side and 17" passenger side replacement windshield wiper blades (and a 13" rear wiper blade if applicable). The 1988 Toyota Corolla FX16 takes 17" on both sides front and a 13" rear. Be sure to always lookup the exact part numbers for the brand of wipers you decide to purchase. This not only ensures the correct lengths but also the correct attachments. See related links below.

User Avatar

I have since traded mine but I think it was made in the Toyota factory about 6 blocks south of here. I have since traded mine but I think it was made in the Toyota factory about 6 blocks south of here.

User Avatar

Go to Autozone's web site and look in their part locater.

User Avatar

If it is throtle body equipped, the idle control s solonoid controls it. If it has a carb there is an adjustment screw on the bottom of the carb.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.