answersLogoWhite
Ask
Clutches and Flywheels
Geo Storm

How do you go about installing a clutch in a 1992 Geo Storm?

585960
Answer

Top Answer
User Avatar
Wiki User
2015-07-15 19:45:20
2015-07-15 19:45:20

this procedure is time consuming however any one can do this so go for it. first write down the radio station pre-sets. then disconnect the negative battery cable.half of the drive train will be removed from the car so manufacture some sort of support for the engine half. then loosen but do not remove the wheel lug nuts and c.v. axel shaft nut at the wheel. raise the front of car as high as possible with strong supports such as jack stands ect. remove the front tires and axel shafts. next remove the starter wiring and other wiring from the transmission as well as clutch cable or slave cylinder and shift linkage remove the transmission and set aside. remove the clutch assembly and in my opinion buy a new one this procedure is long and involved dont skimp on someone elses rebuilt parts. re install in the reverse order.

1
0

Related Questions

User Avatar

i want to know if a new clutch was put in a 1990 geo storm can it break in half in two days just driving arount town

User Avatar

You probobly need to replace the clutch.

User Avatar

adjust the clutch cable on top of the trans. adjust the clutch cable on top of the trans.

User Avatar

VIN number on the dash by the windshield.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.