You can purchase a wire harness assembly [converter] from U-Haul or other trailer supplier. They run about 18.00-32.00 dollars.
SOME U-Haul stores can install it for you for around 30 bucks labor. Most stores are booked and can't do just a wire job. I used to work there. There are full instructions inside the package if you do it yourself.
You will need 2 wheel ramps, unless you are super skinny, since you must run a hot wire from the battery to the converter box. This is not as difficult as it sounds, you will just get a bit dirty.
This installation will require that you remove your tail lights as you will be splicing your existing light wires to the converter.
>Never run a hot lead next to a fuel line or moving parts! It could cause an ignition!
>The wire will most likely be ran on the DRIVERS side.
>Don't for get to set the parking break and chock the wheels!
I would write a tut, but it this installation is dependent on your vehicle. Good Luck!
Trailer wiring harness part #118382 - any local Auto Parts Store should care this.
yes or no if your are towing a trailer or a boat.
If it doesn't have a trailer plug, it does not have a factory trailer harness.
you do not need the extra 7 pin if your not running electri brakes
Buy a kit at Wal-Mart, auto parts or U-Haul comes with instructions
2002 Jeep Liberty 2WD Standard can be towed in neutral. 2002 Jeep Liberty 2WD Automatic cannot be towed. 2002 Jeep Liberty 4WD Standard & Automatic can be towed by placing transfer case in neutral and removing a fuse from the fuse block (ignition fuse). The 2WD Automatic must have the driveshaft disconnected or you must use a tow dolly or car trailer.
A 2002 Jeep Liberty has a timing chain.
AnswerGo to your local auto parts store and get a towing light kit. It will plug directly into your wire harness in the back of your jeep.
Do not purchase a universal harness. Purchase an OEM type trailer harness for your ride and it will fit perfectly and be basically a plug in type. It will cost more but is worth it. The instructions that come with it will describe in detail the installation. The 2002 - 2005's are the same. hitches4less sells the OEM wiring harness. It is basically a plug-and-play installation. Unlike other harnesses, however, the liberty also has a ground wire and a "hot" wire from the converter. After plugging the harness into the exiting plugs, you have to ground the converter, and then run a hot wire (with an inline fuse) to the battery. This hot wire, as per mfgr. provide power to the trailer lights.
how do you chage the fan resistor in a 2002 jeep liberty?
A 2002 Jeep Liberty uses ATF+4.
What distributes power to spark plugs on 2002 jeep liberty
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
Just get a wiring harness form e-trailer for about $30 it is easy to install has instructions with it. Wayne
Where is the speedometer sensor located in a Jeep Liberty 2002?
there is no carb on the 02 jeep liberty, it is efi.
100 foot pounds on my 2002 Jeep Liberty Sport.
The thermostat on a 2002 Jeep Liberty 3.7L is under the housing where the lower radiator hose attaches to the engine.
There are no adjustments in the transmission on a Jeep Liberty.
Dead short in the trailer wiring or one of the trailer light sockets.
It is the round connector, with a cover over it, about 6 inches left of and about at the same level as the hitch receiver.
You can obtain an owner's manual for a 2002 Jeep Liberty through Jeep directly. You can also find manuals for sale ay locations such as eBay.
The 2002 Jeep Liberty 3.7L V6 requires 5.0 quarts of oil.