Ford Probe

How do you hook up the Sleepy Eye Modification on a 1993 Ford Probe GT?

123

Top Answer
User Avatar
Wiki User
Answered
2009-06-08 03:37:07
2009-06-08 03:37:07

---- ---- == == ---- == == ---- == == ---- == == ---- ---- == == ---- == == == == == == == == == == == == == == == == ----

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


diagram of starter in a 1993 ford probe


ford probe gt rims are 7 inch


Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder


its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993


Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.



it is located inside the fuel tank


Brand New 1993 Ford Probe right off the show room floor cost me "$29 800.00"


Not without major modification, no.



if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450


The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.


It is important to check and maintain the fluid levels while owning a car. The transmission dipstick of a 1993 Ford Probe is located behind the engine, to close to the firewall and it has a yellow cap.


they do not come stock with forged pistons, no probe gt does. You will have to buy them and install by yourself


The 1993 Ford Probe oil filter can be found on the left side of the engine. The oil filter will be near the oil pan. The oil filter is easily seen from the bottom of the engine looking up.


The 93 ford probe came with Mcpherson struts all the way around. I am not sure if the base model included rear shocks, but I doubt it. Stan


Ford Probe was created in 1989.


The biggest engine you can fit in a probe is the engine out of the Ford Taurus SHO. I believe it is either 3.0 or 3.2 and requires a lot of modification to fit.


In the dist. Takeit to Auto zone and have them check it out.


Replace the chain and both the cam and crankshaft gears.


follow the coolant hose that goes under the distributor.


on an automatic trans through dipstick tube



According to the manual, .039-.043 inches.


Can a supercharger work on a 97 ford probe



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.