Fuel Pumps
Chevy Blazer
Chevy Trucks and SUVs
Ford Expedition XLT

How do you install a fuel pump for a 1984 Chevy C10 truck?

787980

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 04:47:17
2011-09-13 04:47:17

peice of pie, loosen fuel line at carb- remove fuel lines from pump as well as 2 mounting bolts(sealant applied to threads)-swap pumps.lubricate pivot pin in repl. pump with heavy grease,watch not to let pushrod fall out of block as lever from new pump needs to be aligned underneath it. secure new pump,hook up and tighten lines and you are good to go- mechanical fuel pumps were a drean to install. heres a tip- use o.e.m. pump as they are better quality than jobbers,they have a flow back valve in return line that adds life to pump diaphragm nad be sure to pack the pivot pin area as oil pressure is too low to provide adequate lubrication and will develop a knock in that area.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


the library should have a shop manual for this vehicle :)

Put a gob of wheel bearing grease on the push rod before you install it. It will stay up by itself long enough to get the new pump in.

You must remove the fuel tank , the fuel pump is located inside the tank.

are there 2 fuel pumps on a 1984 chevy citation

IT is in the fuel tank. IT is in the fuel tank.

The 1974 Chevy truck has a mechanical fuel pump with a built in pressure regulator.

2.8L 2BL 1984 Chevy Celebrity The Fuel Fiter should be located in the coupling between the fuel line and the carburator.

remove the bed of the truck.....

It controls / regulates the fuel pressure.

its in the fuel tank, built in as part of the fuel pump.

It is inside of the fuel tank. It is a electric fuel pump.

How is the easiest way to change a fuel pump on my k1500 Chevy pickup

how do you change a pump water on a 2004 Chevy truck k2500 hd

It is INSIDE the fuel tank. In 2004 chevy moved the fuel filter from inside of the drivers FRAME RAIL to the fuel tank.

Yes it will fit but here's the problem. The transmission in the 94 is computer / electronic controlled and it must have all the engine sensors that the 94 engine has to shift right. You would also have to install a fuel pressure regulator to lower the fuel pressure. The 86 engine is NOT a computer controlled engine. You need to install a 1988 through 1995 engine in that truck so you won't have any problems. Then you will be done with it.

It has an electric fuel pump and it is inside of the fuel tank.

You are going to have to remove the fuel tank by disconnecting the hoses and wiring harness.Only then can you access the pump which goes in the top of the tank.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.