Hi! I own a Chrysler Grand Voyager over here in the UK. Don`t know whether your vehicle is exactly the same but I know that a lot of parts off your vehicle will fit mine. I`ve just replaced this particular lamp. It is located immediately behind the push switch in the glovebox. It uses exactly the same bulb that is installed in theheadlamps as position/side/parking lights. The bulb is just a push in bulb, Remove one of the headlamps and take a look at it. , Ian
The lens is held on with two t25 screws. Remove them, pull lens of, reverse to install.
They are not backlit
You can not, you will have to replace the entire tail light.
That light is for low oil pressure, not low level.
If it has a glove box light the light will be located inside the glove box. Just look and see if there is one.
The light for the glove compartment on a 2001 4Runner is in the unit itself. When the glove box is opened the light will turn on.
The brake light switch is above the pedal.
The cause of the code that turned the light on will have to be repaired before the light will turn off.
The abs light stays on when the computer has detected a malfunction and set a trouble code.
There are pages and pages of things that will turn the check engine light on. You need to have it checked for codes, and can diagnose from there.
The meaning of dashboard symbols and warning lights on a Chrysler town and country can be any of things. When you see the light it will mean low tire pressure.
Fuse panel. Open the glove box door and on the left side you will find a black plastic cover. Remove it and there is where the fuses are.