Chevy Silverado
Chevy Trucks and SUVs
Chevy S-10
Heater Cores and Blower Fans

How do you install a heater in a 1983 Chevrolet pickup?

565758

Top Answer
User Avatar
Wiki User
2015-07-15 21:07:10
2015-07-15 21:07:10

have owned an 84 now for 20 years,which is essentially the same truck,over the years,i have replaced all of the heater components(heater core and fan motor),this is a breeze as both peices are fully accessible from under the hood in the passenger side of the firewall- fan motor is a no-brainer as it sits up top staring you in the face(attached by a few screws). the heater core is a little more involved,but still very straight forward- follow the coolant lines into the firewall and you'll see how it is secured.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Every car has a different weight depending on the vehicles specifications. The 1983 Chevrolet CK10 Pickup has a curb weight of 4000 pounds.

User Avatar

There is no fixing a broken motor mount. Replace them with a new ones.

User Avatar

Should be at the side of transmission with a vacuum line attached to it

User Avatar

Drain the water from your 1983 Chevy Caprice Classic cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

User Avatar

1983 Chevrolet S-10 Pickup Bolt Pattern: 5x120.65. Center Bore: 70.3. Hardware:12x1.50 Lug Offset: 00-20mm

User Avatar

what is curb weight of a 1983 Chevrolet Silverado 1500

User Avatar

Chevrolet didn't make the Corvette in 1983.

User Avatar

go to autozone.com and enter your 1983 info and look up water pump,then on right side of screen,click on repair guide and it will tell your how to remove and install new one.

User Avatar

The fuel pump on a 1983 Chevrolet Citation is under the hood. It is mounted on the lower part of the engine block.

User Avatar

On 83 heater core 4 or 6 nuts on fire wall under hood remove hoses go into pass side and remove glovebox if needed and disconnet cables and pull heatererore box out change heat core

User Avatar

You will need to loosen the tensioner pulley on your 1983 Chevrolet S 10 pickup truck. Slide the tensioner pulley to the left. The serpentine belt will become loose. Put the new fit serpentine belt on and tighten the tensioner pulley by sliding it to the right.

User Avatar

Chevrolet Celebrity uses negative ground, there is no positive ground.

User Avatar

Look at the lower end of engine

User Avatar

Around 3600-should be on registration.

User Avatar

I found the answer on AutoZone.com There was a section on repair info and then go to Heater Core GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide. It has a detailed guide and pictures. Good Luck!

User Avatar

They have struts in the front and shocks in the rear.

User Avatar

i have a 1983 Chevy k10. it uses GM corporate 10 bolt axles with 2.73 gears

User Avatar

$7,000 to $10,000 Example, 1983 Chevrolet Impala 4 door sedan sold for $8556.00.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.