Go to CB7tuner.com and I'm sure one of them will help
i have a 1995 Honda accord 4 cylinder v tec the tail lights sides lights and the dash lights stays on at all times have already replaced the headlight switch and still have the same proplome
Freeze plugs on a 93 Honda Accord are located along the front and sides of the engine block. They are designed to prevent the engine from being cracked in the event the coolant completely freezes.
No, you do not have to use them. It is not mandatory. However you will find they do help keep the sides of your car clean.
Open the glove box, push "in" on both sides of glovebow to allow it to fall forward. The filter is behind the glovebox door, squeeze both sides of filter holder inwards, and pull out.
Remove the glove box by pushing in the tabs on the sides and tilting it down. The air filter is behind the box and should slide right out.
On the 1995 Accord Wagon the SRS unit is located adjacent the accelerator pedal, on the "hump" behind the carpet. Its pretty easy to get to from both drive & passenger sides and you will need a Star/torx bit to remove bolts. On the sedans it should be under the radio and forward the shifter
The 5 digit radio code is specific to each and every radio. Look in the glove box for a white card with the code written on it. Look on the sides of the glove box, and look in your owners manual. If you cannot find the code go to the Honda Owners link I will post. Click the link and register your Accord. After registering it, you will be able to get the code for free. Just click Retrieve Radio/Navi Code.
No, one should be positive and the other would be grounded through the electronics. If your testing the leads with a test lamp both sides will light up the test light because one side is hot and the other side you are providing the ground with the test lamp causing the light to illuminate.
05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.
fuel pump locationfuel fillters are normally mounted to the underneath of the car...along the sides.. most times on the passengerside... youll have 2 remove the cover that protects it from the elements......hope this helps.....
behind the glove box. push the 2 black tabs located on the sides of the glove box, outside going in, pull the glove box down, you will see the cover to the pollen filter's compartment. push the tabs on both ends of the cover, pull back towards you, replace the filter and put back in reverse. make sure to follow the arrows on the filter
behind the fuse panel. unit has a metal perforated cover, 4 pins on bottom. It is gray and plugged into the bottom of the fuse box. I had to carefully pry it out with a screw driver. note the tabs on the sides holding it in.