get a serpentine tool from an auto parts store ...theyll let you borow one
It needs one sepentine belt........If the Corolla has AC it needs one sepentine belt w/ac
need diagram of the sepentine belt and how it go on.
Sepentine-replace tensioner,v-belt, adjust accessory and tighten.
yes I am going to do this tomorrow if you list the year I might even be able to list the part # for the belt
the 3.1 liter v6 and the 4 cylinder both have sepentine belts
Go to www.dayco.com and type all information into page and it will show you the belt routings. Works on any car, truck, van.
take the load of the idler pully and the belt will come right off. make sure you know the correct rout for the belt so you can put the new one on correctly..
Crown is provided so that the belt should remain in the centre of pully rim. In the absence of crown the belt will slip sideways. - Deepak
if this is the 3.1L v6 version, then there is a belt tensioner pulley on the left side of block.,,, ( looking from the passenger side of the car it is left side) Loosen bolt holding it on and it will release tension for it to turn and loosen the belt
As long as the belt looks okay it should be alright. Check to see if there are lots of cracks in it. Also if it is starting to fray around the edges then it is time. Good luck.
Yes, having a belt too loose will cause a sepentine belt to squeal, check tension by lifting the belt upwards with your finger and continue tightening until you can only move the belt about a half inch either way. Too tight and the belt will have a much shorter life span.
how do you install a serpentine belt on a 1996 corsica?