0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the turn signal relay in a 2001 Pontiac Sunfire?
There is no relay. The flasher in under the dash on the left of the steering column
Where is the turn signal flasher located on a 1997 Pontiac Sunfire?
under dash drivers side mounted above the brake pedal
Where is the signal flasher located on the 1995 Pontiac Sunfire and how do you get to it to change it?
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
Why do the turn signals on your Pontiac Sunfire not flash?
check your fuses first, then check your bulbs and then your relay.
Why doesn't the signal lights work on a 1999 Pontiac Sunfire?
Well, if none of them work, (front or back) I'd suspect a fuse or the flasher. Do the 4 way emergency lights work? If so, they operate on a separate flasher and this would indicatethat the turn signal flasher is bad.
Where is the turn signal flasher located on a 1995 Pontiac Sunfire?
Pull off panel under steering wheel. You will see two separate flashers. Replace the one on the right.
Where is turn signal flasher located in a '91 Pontiac Sunbird?
The 1991 Pontiac turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
Where is the turn signal switch for a 98 Pontiac sunfire?
under the dash
Where is the turn signal flasher in a 2004 Pontiac Grand Am?
where is the flasher relay located in 2004 grand am
Where is the blinker relay on a 1996 Pontiac Sunfire?
My Haynes manual says that the "96 turn signal/hazard flasher is plugged into the "convenience center" which is mounted at the top of the left kick panel. FriPilot
Where do you find the signal light flasher on a 97 sunfire?
Your car has a combination signal/hazard flasher. It's plugged into the "convenience center" which is mounted at the top of the left kick panel.
Where is the turn signal flasher on a 1998 Pontiac Firebird?
The turn signal flasher is mounted behind the instrument panel on the driver knee bolster bracket. To replace the turn signal flasher 1) Disconnect the negative battery cable. 2) Remove the clip and flasher from the instrument panel tie bar. 3) Detach the electrical connector 4) If necessary, remove the flasher from the clip. To install: 5) If removed, install the turn signal flasher to the lamp. 6) Attach the flasher electrical connector. 7) Attach the clip to the driver knee bolster bracket. 8) Connect the negative battery cable. Information located at Autozone.com
