answersLogoWhite
Toyota Corolla

How do you install a speedometer cable on a 1992 Toyota Corolla?

636465

Top Answer
User Avatar
Wiki User
2015-07-15 21:05:48
2015-07-15 21:05:48

depending on if its lower spedometer cable located inside the engine compartament. if its that one look for a cable near the transmission right below the intake ducting it should have a red stripe around it when you locate that just loosen it from the transmission and from the other half. Then if its the upper spedometer cable u need to take of the dashboard bezel/radio trim then remove instrument cluster go under dash and look for the cable that cable should be near the top of the brake pedel once it is spotted you must disconnect the one in the engine compartament and just pull it threw carefully then do the same when installing it.

1

Related Questions

User Avatar

sounds like the cable broke usually on the transmission end

User Avatar

Speedometer cable replace 1989 toyota

User Avatar

There is no cable.. its electronic

User Avatar

You may need to replace the speedometer fuse. The speedometer cable can cause your speedometer to stop working. The speed sensor can also cause the speedometer to stop working.

User Avatar

Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.

User Avatar

No speedometer cable, it is electronically controlled from transmission.

User Avatar

si http://www.corolland.com/corolla/1993-1997/1993.html

User Avatar

there is not one it's electronic

User Avatar

To change the speedometer cable on a 1990 Toyota truck, disconnect the cable, feeding it through the grommet, then disconnect it from the transmission. The process can then be reversed with the new cable.

User Avatar

The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.

User Avatar

how to replace the SPEEDOMETER cable on a 2003 kawasaki voyager

User Avatar

You can get a speedometer cable for your 1990 Toyota pickup truck at most auto-parts stores. Many Toyota dealerships have auto part departments open to the public.

User Avatar

The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.

User Avatar

The 95 Camry does not have a mechanical speedometer cable. There is a speed sensor located on the top of the transmission that is connected by wire to the speedometer.

User Avatar

Your 1988 Nissan 300 speedometer cable is held in place with swivel nuts on each end of the speedometer cable. Turn the swivel nuts to the left. The speedometer cable will come off. Reverse the process to install your new speedometer cable.

User Avatar

there is no cable. it has an electronic transmission with wires

User Avatar

There are a few reasons that could cause the speedometer to stop working on your Toyota Camry. If the mileage is still working then the speedometer cable end is damaged. If both the odometer and speedometer do not work then the cable is most likely broken.

User Avatar

speedometer cable is gummed up inside the housing.Remove cable from speedometer.Pull out inner cable. Lubricate with good grease and install.

User Avatar

Remove the dashboard cover. Remove the retaining ring, from the speedometer. Remove the speedometer cable from the back of the speedometer. Reverse the process to install the new speedometer.

User Avatar

Sure you can. Just remove the old battery and install the new one identically as the old one was connected. Disconnect and reconnect the negative cable first.

User Avatar

Remove speedometer head to unscrew and remove cable Remove cable from transmission Re-Install new cable using same routing as original

User Avatar

how do i install a speed domotor cable on a 1995 f150

User Avatar

The 1996 Geo tracker speedometer cable is held in place by a retaining nut at each end of the cable. Loosen the retaining nuts. Remove the speedometer cable guide retainers. Reverse the process to install the new speedometer cable.

User Avatar

First remove battery cable. Second install your key and turn it to on. Third reinstall battery and all should be fine.

User Avatar

Remove speedometer head Disconnect old cable Follow original routing for new cable Disconnect fitting at side of transmission and remove cable - replace with new


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.