answersLogoWhite

0


Best Answer
Copy

Remove the negative battery cable then follow the posative cable and find the starter. remove the wires and mounting bolts and work the starter out. Sometimes the bolts are hard to get to.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:36:46
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you install a starter in a 1987 Nissan Maxima?
Write your answer...
Submit

Related Questions

Does a 1987 Nissan Maxima and a 1994 Nissan Maxima have the same transmission?

You probably have gotten an answer by now ,but no they do not '88 was the last you for that transmission after that the became computerized


Where is ignition control module 1987 Nissan Maxima?

under the coil


Does a 1987 Nissan Maxima have a cambelt or timing chain?

According to the Gates website , the 3.0 liter V6 in a 1987 Nissan Maxima : has a timing BELT , it's an interference engine , and change the belt at 60,000 miles


How do you change a fuel injector in a 1987 Nissan maxima?

Where is the fuel injector located?


Where is the ECU located in a 1987 Nissan Maxima?

Under the Right Front Passenger Seat


How do you reset the alarm system on a 1987 Nissan maxima?

Passenger side door, with your key.


What is the firing order on a 87 Nissan maxima 3.0l dohc?

The firing order for 1987 Nissan Maxima 3.0L DOHC is 1-6-2-4-3-5. It is the same for several years surround the 1987 model and is in a counterclockwise direction.


Your 1987 Nissan maxima security light continues to flash after you have locked the door with the key Is it suppose to do this?

Yes.


How do you locate remove and install the starter on a 1987 Nissan Stanza?

starter is located on drivers side below intake manifod very hard to see it, easier to see from underneath it attaches with one bolt from bell hsg. side and lne from starter side.


How do you replace the starter on a 1987 Nissan 200SX?

cant see bolt on other side off starter, how to replace it ?


Where is the starter located on 1987 Nissan pickup?

above the oil filter,to the left.


How do you change a transmission filter on a 1987 Nissan maxima?

Does not have a filter. There is a screen in the transmission which generally needs no service.


1987 Nissan truck 4x4 where is the starter located?

above the oil filter ,to the left.


How to install a starter on 1987 ford bronco 2?

Secure the starter by tightening the starter retaining bolts. Connect the cables on the front of the starter. Connect your positive cable to the battery.


How do you change the starter on 1987 blazer s-10 with manual trans?

Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you install a thermostat on a 1987 Nissan 300ZX?

To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.


What should you do if the fuel injectors are flooding on your 1987 Nissan Maxima and there are problems with starting?

The original fuel injectors on that model were recalled - did you ever have them replaced?


Is there valve clearance on a 1987 Nissan Maxima?

The 1987 Nissan Maxima VG30E engine uses hydraulic valve adjusters (also known as "cam followers") which cannot be adjusted. Therefore, there is no specific valve clearance. If you hear valve noise, it could indicate that there's either excessive wear of valve train parts or clogged hydraulic adjusters.


Where is the starter relay located on a 3.0 V6 1987 Nissan Pathfinder?

Inside the right of the engine compartment, near the battery.


Where is the starter relay on a 1987 Nissan Pickup and is it the same as the ignition relay?

follow the wire from the positive side of the battery it will lead you to it


Where do you put the power steering fluid on a 1987 Nissan Maxima?

In the power steering reservoir. Which is located on the passanger side next to the firewall right next to the hood hinge.


How do you change the starter on a 1987 Nissan Pathfinder?

First disconnect the + side of the battery. The starter is on the right side of the engine (when you are facing the truck) accessible from underneath the truck. This is also under the oil filter, so you may want to degrease the starter before you start. Secure the truck on jack stands. Disconnect the wires on the back of the starter (two wires and a plug), then remove the two bolts holding it in at the back. Voila! Reverse process to install new starter.


How do you replace the water pump on a 1987 Nissan Stanza?

Drain the water from your 1987 Nissan Stanza. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.


How do you remove and install a starter on a 1987 Nissan Stanza?

Oh yeah dude, easy. Remove the frame rails on the bottom of the car right under the starter (below the throttle body) then take off passenger side wheel, remove that from the transaxel (some working space) then remove the engine mount that is in your way. Just rip out the starter, take it to a parts shop, get a new starter and your core back =) and stick the new one in! Hope that heps!


How do you change the starter on a 1987 virago motorcycle?

How do you change the starter on a 1987 virago motorcycle