Look for #2057 bulb(Sylvania) You have to pop out the trunk trim from inside the trunk - it has plastic fasteners so you really have to pull hard. The carpet may also be hooked, so just un hook it. You should have 4 nuts on the inside of the trunk for each side take these loose and you'll be able to switch the bulbs from outside the trunk. Make sure your brake lights work - on a 626 the 2 tailight bulbs are the same as the brake lights.
i need a diagram to show me how to remove a starter on millenia s 1999 mazda
The 1999 Mazda Millenia OBD 2 port is on lower right corner of dash; next to tunnel
How do you install a rheostat in 1999 626 Mazda?
Should be a 15" wheel. My 96 was.
on a 2.3, it is behind the radio, and is not easy to remove
2.5L V-6 Mazda Millenia engine is a non-interference engine. If your timing belt pops, you will not damage your valves, like I did in my Diamante
It is in the Trunk up by the back seat
call your local dealer
Possibly a vacuum line came undone
Well if it's supercharged, its the 2.3L. If it's the non-supercharged, then its the 2.5L.
Because you have a short in your steering column wiring.
driver door panel........near bottom i know awkward place.
Trouble code P0720 means: Output Shaft Speed Sensor Circuit
A flashing check engine light means an engine cylinder misfire has been detected
I have 120k on my 1999. What typically get these is the engine or the transmission at around 150+ I rarely see folks on these things tallking about higher....
You did not install the belt correctly. It is more than likely out of time. I would advise you to have an expert look at it. You're lucky in that this is not an interference engine otherwise you would've had serious damage when you attempted to start the engine.
ngk 3741(pzfr5f). do NOT use pzfr5f-11. -11 means the gap is 1.1mm, WAY to big
If your standing in front of the car it go's left to right, back 1..3..5 and the front 2..4..6
Check the toothed wheels and sensors behind the drive wheels for crud/corrosion and clean/change as necessary.
it supplies power to certain items constantly; even with the ignition switch off. pcm, clock, dome lights, to name a few.
take it to a shop its behind the timing belt cover you have to take every thing off the front of the engine including the motor mount!!!
supercharger seals could be bad
I haven't seen one. To drain the system you need to open the pressure cap and unclamp one of the lower end water hoses.
Your dashboard lights suddenly not working is almost always your indication that your taillights are out. If the fuse for your taillights is blown and you replace it, your dash lights should be fine.