bolts the compresor to mounted bracket, conect the refrigerant lines on compresor,conect the clutch wiring harness replace the drivebelt.
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.
They are mostly identical, yes.
What is the fuel tank capacity of a 1997 Mercury Villager van?
According to the 1997 Mercury Villager Owner Guide : ( 20.0 US. gallons )
what is the spark plugs firing order for a mercury villager 1997
You can check the timing on your 1997 Mercury Villager with a diagnostic tester. The diagnostic tester will give you a printout detailing the timing sequence.
You will need to drain the water from your 1997 Mercury Villager cooling system. Remove the water pump belt. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
There is no such device on a '97 villager.
The Villager does not use fusible links that I am aware.
You need to ask a complete question.
In the fuel tank.
On the radiator.
Yes , the 3.0 liter V6 engine in a 1997 Mercury Villager is an interference engine ( according to the Gates website , they make timing belts etc . )
The 1997 Mercury Villager van has an EPA estimated city/highway mileage of 16 and 21 miles per gallon (mpg). The Villager wagon is also rated at 16/21 mpg.
About 3900 lbs.
On a 1997 Mercury Villager open the drivers door and on the latch pillar you will see an information sticker that shows the original size tires on the vehicle from the factory
On a 1997 Mercury Villager : The spare tire is underneath the vehicle , just ahead of the rear bumper You can view the 1997 Mercury Villager owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides ( starting on page 257 the manual shows with diagrams how to lower the spare tire )
According to the 1997 Mercury Villager Owner Guide : The jack is behind a removable plastic panel , in the cargo area , on the passenger side ( there is also the tool kit with the lug wrench )
The fuel pump is in the fuel tank.
At the engine end of the upper radiator hose.
No such option was available.
Error codes on a 1997 Mercury Villager can be found by connecting an OBDII code reader to the diagnostic port. The service manual has a full list of error codes and their causes.
According to the 1997 Mercury Villager Owner Guide and one of Fords websites : The spark plugs for the 3.0 liter V6 engine are gapped at : ( .034 inch )
The Villager has an upper and lower intake manifold. It is at the top of the engine with the throttle body attached to it.