Best Answer

you losten the belt with the tensioner pulley. it is located below and to the rear of the alternator. it will take a 13mm box end wrench and I also use a 17mm box end for leverage. you will pull the wrench toward the rear of the car and slide the belt off of the alternator.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:51:50
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you install an alternator belt on a '94 Grand AM?
Write your answer...
Still have questions?
magnify glass
Related questions

Drive belt on alternator wont turn on 94 corolla?

The drive belt on the alternator of a 94 Toyota Corolla won't turn if the bearing has seized. The alternator will need to be replaced.

Will an alternator for a 94 Grand Am fit a 97 Grand Am?

it should fit

Where is the voltage regulator on a 94 grand prix?

Inside the alternator. In the alternater. Sorry, in the alternator.

How do you change the alternator belt on a 94 GEO Prizm?

You can change the alternator belt, on your 1994 General Motors vehicle, by loosening the tensioner pulley. The loosened the tensioner pulley will create slack in the belt. Remove the belt and replace with a new belt.

How do you replace an alternator on a 94 buick lesabre how do you get the alternator off the belt is in the way how do you losen the belt to get the alternator off?

Check out which has online repair manuals. The manual (which is almost a copy of chilton's manual) says to rotate the tensioner and pull off the belt before removing the alternator.

Battery light stayed on 94 ford excort?

Bad alternator or loose or broken belt.

How do you release tension on the power steering belt in order to change it on a 1994 Mazda Protege?

i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l

How do you install a water pump on a 94 Grand am 2.3?

take the inner fender wall out

How do you change alternator 94 Lincoln mark viii?

its on top of the engine in the center, there are two bults that hold it on, reduse tention on the belt tentioner to get the belt off it

Why after changing your alternator do you have some sort of scraping clunking ticking noise Its not the alternator maybe have knocked something else 94 Hyundai scoupe 1.5 L engine?

Did you check if the belt is on the pullys right ? A belt that isn't on the groves right will cause a rubbing. or you might have a alternator with bad bearings. or the belt is to tight.

Does a 94 Jeep Grand Cherokee Laredo 2wd have a timing chain or belt?

timing chain

How do you change a serpentine belt on a 94 grand am?

You will need to loosen the tensioner pulley on your 1994 Pontiac Grand Am. The old serpentine belt will come loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.

People also asked