If you want to keep your radio stations they sell a plug for your cigarette lighter that holds a 9 volt battery, this will keep your stations and also your memory on your computer so it wont have to relearn its idle strategie after you reconnect your battery. Plug this in First, THEN disconnect your battery.Then loosen the top bolt on the alternator, remove all wires on the alternator, remove belt, remove completely the bottom bolt. Hold on to the alternator and remove the top bolt completely then remove alternator. Install in reverse procedure.
how do you install alternator on 2000 Ford diesel truck
How do you install an alternator belt on a 1986 GMC s15 pickup truck
A bad battery, distributor, or fuel relay can all cause the 1991 Mitsubishi Mighty Max 2.4 truck to die after start up.
Need a diagram to set the timing Mitsubishi 1991 pu
Could be ignition module
Should be right next to the fuel tank underneath the truck bed.
Remove the belt from your 2001 Chevy S 10 pickup truck alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
Install a good generator or alternator.
when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections
Get under your truck, the starter is going to be where the bellhousing of the tranny meets the motor. you'll see where it is as there will be an irregularity in the bell housing.
The duration of Mighty Truck of Stuff is 3600.0 seconds.
There are two bolts on the bottom of the alternator that you can't see but you can feel them, these are the pivot bolts, remove them. Then remove the adjustment bolt on top of the alternator. Remove wiring from back of alternator. Reverse instructions for install.
where is the fuel pump in a 1987 Mitsubishi Truck
Mighty Truck of Stuff ended on 2006-07-08.
Mighty Truck of Stuff was created on 2005-10-15.
HOW DO I INSTALL A TIMING BELT ON A 4D56 ENGINE
Start replacing the 2000 s10 alternator by disconnecting the battery. Remove the air inlet hose, and the serpentine belt. Take off the bracket over the alternator if it has one. Unbolt the alternator and disconnect the wires. Reverse the procedure to install the new alternator.
You will need to use the users manual to help with this. It will give you the information that is needed.
Disconnect the battery. Remove the air inlet tube. On some s10s, there is a bracket above the alternator that needs to be removed. Take off the serpentine belt. Remove the alternator wiring, then the bolts. Remove the alternator and install the new one.
2008 Mitsubishi Raider, 1996-2006 Mitsubishi Triton, 2006 L200 chassis cab, and 1996 Mitsubishi L300 are some of the most popular Mitsubishi truck models.
remove the bad one buy a new one install in reverse order of removal
the front of the engine is 1 2 3 4 cylendrs and fireing order is 1342 and turns clockwise i need a pic of timing marks on 91 mighty max with 2.4
buy a haynes or a chiltons repair manual for your truck both provide detailed repair instructions
The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.