Best Answer

6.0L PSDs usually come with the block heater installed, but no cord. it is located under the starter on the passengers side

User Avatar

Wiki User

โˆ™ 2008-12-24 17:50:53
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you install an engine block heater in an 2006 f250 6.0l?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you install an engine block heater 2006 Chevy trail blazer V6-4.2L?

Drain coolant from radiator and engine block Remove passenger's side rear freeze plug and replace with block heater kit

Where is the engine block heater located on 2006 Pontiac g6?

I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.

Where is the block heater plug on 2006 dodge ram?

The block heater cord was an add on accessory. If equipped, it is located on the passenger side of the engine

Block heater location on 2006 Nissan altima?

where is block heater on my altima 2006

Were is the block heater cord on a 2006 Monte Carlo?

It may not have come with a block heater as an option. You could always install a magnetic one try are very simple and effective

Were is the block heater on 2006 Mazda 3?

where is the block heater cord located on a Mazda 3 2006

How many watts does a 2006 Ford freestar block heater use?

I ASSUME the block heater in a 2006 Ford Freestar would use ( 600 watts ) like my Ford Explorer 4.0 liter V6 engine does

What is the location of the block heater on a 2006 Malibu?

yes there is a heater on that car

Where is the engine block heater on a 2006 6.0 diesel?

It is on the block on the passengers side above the starter. If it has a cord on it the cord will be behind the bumper on the passengers side. the block heater is standard but the cord was a cold weather option. If no cord you can buy one from a ford dealer.

How do you install an engine block heater on a 2006 Jeep Wrangler?

On most block heaters I've seen you have to knock out a freeze plug (preferably in the center of the engine so the heat will disapate evenly) and install the heater there. They're simply inserted into the vacant freeze plug opening and tightened up. Its a little more involved than that: on my '04 TJ -6cyl, the dealer had to install my blocker heater, since the frost plug is located directly behind the AC compressor, this has to be removed for access, the freon is purged and then recharged after, the cost is about $150-170 which includes parts and labour. Red Ryder.

Did the 2006 outbacks come with factory installed block heater?


Is the block heater standard on your 2006 Dodge diesel?

The heater will be in the block behind the oil filter. The cord was optional. You generally have to buy it from the dealer.

People also asked