Get a manual on your car from DISCOUNTAUTOMANUALS.COM You take the a/c ducts out not the dash.
The dash needs to come out, at least pulled away as far as it can without disconnecting the wiring... the strips on the dash just unclip, the strip up by the window has screws across, about 5, remove the panel under the dash, drop the column, there are a couple nuts on studs, big ones on the drivers side, smaller on passenger side. the pass side needs to come out further, but it will be enough to get all the screws and then pull the air box out, watch out for the vaccum lines and control cables, they need to come off, make sure they go back on the same, also be carefull putting the heater hoses back on, you can break the outlet if your not carefull, put wd40 or soapy water on the hose ends so it will go on easy. A chiltons book will spell it out for ya, it is doable, allocate about a day or day and a half. Good Luck
How to remove the heat core housing on a 2001 crown Victoria? I remove the dashboard, can't get heat core housing out.
You do not need to completely remove the dashboard in order to change the heater core. Remove the water hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
How do you remove the dashboard on a 1996 Ford Fiesta
remove radio, heater control, glove box, dashboard trim & bezels. once you do this you can see a tublar bar which the dashboard secured to. remove the dashboard and the heater core is there in the center
remove the dashboard face then you should beable to remove and put in your new stereo u may have to take out the heater cointroll unit to get do that
It is on the passenger side, you have to remove the dashboard.
Disconnect the negative battery cable.Drain the cooling system into a clean container for reuse.Remove the air cleaner and duct assembly.Remove the wiper linkage.Remove the heater hoses from the heater core.Remove the lower center console.Remove both instrument panel insulators.Remove the heater outlet module screws.Remove the heater cover.Remove the heater core mounting clip and line clamp screws.Remove the heater core.Install the heater core.Install the heater core mounting clip and line clamp screws.Install the heater cover.Install the heater outlet module screws.Install both instrument panel insulators.Install the lower center console.Install the heater hoses from the heater core.Install the wiper linkage.Install the air cleaner and duct assembly.Refill the cooling system.Connect the negative battery cable.Run the engine to normal operating temperatures; then, check the climate control operation and check for leaks.
First remove the dashboard to access the heater box and core! Then reversal of strip down to rebuild.
you have to take out the whole dashboard
remove the entire dashboard.
Remove the water from your 1998 Chevy Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
The heater coil is located behind the dash board. You will have to remove the dashboard to get at the heater coil
You first have to take the passenger side (bottom) dashboard out. You then remove (approx) 3 bolts from the inside and (approx) 2 nuts from the motor side. The heater core is inside the heater box. When the box comes off, you then remove the heater core from the box - after removing about 6-8 screws. It is more difficult than it sounds.
No................... Its located in the center of the vehicle but you will need to remove the side panels if equipped and then remove the lower heater core cover and the heater hoses.............
do you need to remove dashboard in 2003 chevy impala to replace heater core
Remove the water from the cooling system. Remove the water hose from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.
Start by draining the coolant, disconnect dash board wiring harness from pcm behind kick panels, disconnect eye shaft, unbolt dashboard and remove dash. (Remember to tape steering wheel in place as it might have a clock spring). You might have to remove some trim panel on top of dash or cluster from dashboard to gain access to retaing bolts, disconnect heater hoses from heater core in engine compartment and remove heater core, reverse install.
Remove the water supply hoses from your heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
You must remove the entire interior dashboard..
Remove the water from the cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
How do you remove a heater core on a 1995 Audi A6?
If you install Adblockers on your Browsers then no ads will be displayed
Remove the water supply lines from your 2001 heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
You will need to remove the water lines from your heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.