Standard brake removal and installation.
Tools required: Jack and jack stands Tire iron Socket set with 'Torx' or 'star-drive' bits. Screwdrivers C-Clamp (or something to push the caliper back in) band-aids and neosporin.
Procedure overview: Remove cap from brake fluid reservoir, block rear tires, loosen (but don't remove) lug nuts, jack up the car and place jack stands for safety (you don't want 3,000+ lbs. of van landing on you). Remove lug nuts and wheels. Remove the caliper mounting bolts and detach the caliper from the steering knuckle. Use C-clamp to push the piston into the caliper. Use a screwdriver to remove the old pads. Installation is the reverse of removal. When done, step on the brake pedal a few times, and check brake fluid level, filling as necessary.
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.
It would be to your advantage to take your car to a Brake Repair Shop if you have to ask that question brakes are not something you should do if you do not have the skill, WBMS
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
Front wheel drive
Bottom front of engine.
It is on the front of the engine on the end of the crankshaft.
In front of the engine, down in the "V".
At the front of the motor attached to the engine cradle.
On the front of the engine in the center of the "V".
On a Mercury Villager , V6 engine : firewall 1-----3-----5 2-----4-----6 front of vehicle > driver
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.
On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine
front wheel drive
Bottom front of the engine under the A/C compressor.
Firewall 135 246 Front of car
It depends which "pulley" you mean. Drive pulleys are on the front of the engine.
On a 1999 Mercury Villager , 3.3 litre V6 engine : firewall 1-----3-----5 2-----4-----6 front of vehicle > driver
Valve cover? Engine seal/ front or rear?
Cut it out and weld a new one in.
On the front of the engine, the thing with the spark plug wires attached to it.
The trans axle is the transmission on a front wheel drive vehicle
On a Mercury Villager , 3.3 liter V6 engine : The firing order is ( 1 - 2 - 3 - 4 - 5 - 6 ) The engine cylinder locations are numbered : firewall 1-----3-----5 2-----4-----6 front of Mercury Villager
Remove the glove box. The front blower motor and the resistor can be accessed from there.
Bottom front of engine.
Front bottom of engine under the A/C compressor.