i did it on my 2001 intrigue, pretty easy, but make sure you have enough ventilation. Remove the cover from the trunk and locate the tank lock at the trunk. With a flat head screwdriver , tap the cover till it comes loose. (tool not needed) then you will be able to pull pump and replace in reverse order. took me about 45 min. (have to get in and out of trunk few times. (try to do it with a low level of gas in tank. & avoid gas fumes by doing job in well ventillated area, i did it under a tree outside)
No, they are two seperate sensors.
How do you install an oil level sensor 2007 Tahoe
hi, fans will work when power is jumped direct to fan wiring, . but not with relays or sensors, replaced relay number one but still not working as factory set up. is sensor on radiator a coolant level sensor or fan sensor to trigger relays
Unfortunatly there isn't one. I am actually looking for an aftermarket oil level sensor to install in my 1994 silverado.
If the oil level is fine, your oil level sensor or the sensor wiring is malfunctioning. Same for the ABS system. Check ABS fuses.
I took this apart and found no sensor on the overlow what so ever. Could it be located somwhere else? was this a change over year? At the bottom of the overflow can (where you fill it up).
The fuel level sensor is shorted or a wire is shorted.
If the coolant system (radiator and reservoir) is full and the light remains on, the probe on the coolant level sensor is probably dirty. Remove it from the radiator, clean it gently with brake clean and an old toothbrush, re-install it, refill coolant system and you should be good to go.
The low water level sensor is in your radiator overflow resivoir. The reservoir is supposed to have a certain amount of coolant in it but if it's low, the light comes on. This has nothing to do with the radiator being empty. True, if the reservoir is left unchecked the radiator may eventually become low and then you will overheat but until then, it's just telling you the reservoir is low.
There are many types of level sensors you can use to measure the water level in a tank such as submersible level sensor, ultrasonic level sensor, float level sensor. If you are searching for a level sensor you visit our website iconprocon[dot]com
It should reset itself when the coolant is back to the appropriate level as long as the sensor is working properly. If you look in the overflow reservoir and can see coolant, the sensor or wiring might be the problem.
The book says remove the exaust cross over tube but two 19mm or 3/4 open end wrenches and patients will get the sensor replced. located below the motor mount and thermostat housing above the transmission.