Your projector headlights should come "plug n play" and have the female ends for your existing connects on the wiring harness. As for the additional wires for the halos the best or easiest way I found was wiring them into the parking light circuit. This worked for my projectors on my truck.
Most replacement headlights come with plug and play assembly! So all u will need is a socket set, and remove three screws from each headlight! Once screws are off, u disconnect the plug, and remove ur old headlight assembly!Grab ur new halo headlights, set them in place, plug them in, put the screws back on and ur done!
***CAUTION***The halogen bulb contains gas under pressure. The bulb may shatter if the gas envelope is scratched or if the bulb is dropped. Handle the bulb carefully. Grasp the bulb only by its base. Avoid touching the glass envelope. è The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp. Headlights Removal & Installation 1. Raise and support the hood. 2. Raise the headlamp retainers by pushing rearward and pulling up. 3. If equipped, rotate the headlamp bulb protective counterclockwise and remove. 4. Disconnect the headlamp bulb electrical connector. 5. Remove the headlamp assembly. 6. Rotate headlamp bulb retainer counterclockwise and remove. 7. Remove the headlamp bulb by pulling it straight out with a gentle up-and-down rocking motion. ***WARNING*** Do not touch the glass bulb with your fingers. Oil from your fingers can severely shorten the life of the bulb. If necessary, wipe off any dirt or oil from the bulb with rubbing alcohol before completing installation. To Install; 8. Install a new bulb into the headlamp assembly. 9. Install the headlamp bulb retainer and turn it clockwise to engage the retaining tabs. 10. Attach the bulb electrical connector. 11. If equipped, install the headlamp bulb protective cover. 12. Install the headlamp assembly. è Be sure the headlamp assembly is positioned correctly with the alignment pins inserted into the proper holes and onto the ribs of the reinforcement. 13. Engage the retainers by gently pushing down. 14. Turn the lights on and check the bulb operation.
Stick them in
what is the euro 2008 install password
There was a partial lunar eclipse on August 18, 2008.
No
There was a total lunar eclipse visible throughout the US on February 21, 2008.
Rookies - 2008 I Tampa A Deer in the Headlights 1-8 was released on: USA: 11 November 2008
The Eclipse - Heroes - was created on 2008-11-24.
2008
Aug 1,2008
Attractive - 2008 was released on: USA: 4 October 2008 (Lumen Eclipse)
Bum Reviews - 2008 Twilight Eclipse 3-11 was released on: USA: 4 July 2010
The last total solar eclipse for Dallas was Feb 20th 2008
Where is number 2 cylinder located on the engine of my2008 Mitsubishi Eclipse