FIRST JACK CAR UP AND REMOVE WHEEL. SUPPORT CAR WITH JACK STANDS AND PLACE FLOOR JACK UNDER REAR DIFFERENTIAL BOX IN THE BACK AND JACK UPWARDS ABOUT 10 INCHES. REMOVE SHOCK BOLTS AND NUTS. IF LOOSENING BOLTS PROVES DIFFICULT APPLY HEAT DIRECTLY TO BOLT USING A TORCH UNTIL BOLT TURNS RED AND LET COOL FOR ABOUT 30 SECONDS AND THEN REMOVE LOWER NUTS AND BOLTS.WHEN NUTS AND BOLTS ARE REMOVED RELEASE JACK PRESSURE AND REPEAT BOLT REMOVAL PROCESS FOR UPPER SHOCK NUT AND BOLT REMOVAL. PRY OUT OLD AND WORN SHOCKS AND REPLACE WITH NEW ONES, INSTALLING UPPER SHOCK BOLTS FIRST THEN ADJUST JACK SO THAT YOU CAN INSTALL LOWER BOLTS. WHEN BACK IS DONE DO FRONT THE SAME WAY EXCEPT THERE IS NO DIFFERENTIAL BOX SO YOU WILL HAVE TO JACK UP EACH ADDITIONAL FRONT SUSPENSION ASSEMBLY AND REPEAT STEPS BEING CAREFUL NOT TO PINCH ANY LINES. ***GOOD LUCK***
bottom front of engine
ECM is a common problem with this type of car engine
Check every hose line one by one and it's connection to the engine. Some hoses rot at the connections and can be cut back and reattached. If not - install new hose.
go to OBD codes.com they have them for everything sandi
Lap and Belt
use dextron II or power steering fluid, this age of car was not picky
1-6-5-4-3-2 click the link for a photo of the wiring.
Phi Beta Delta was created in 1986.
how do you install a aftermarket radio in 1986 caprice
Delta Lambda Phi was created on 1986-10-15.
In the lower part of the armrest, there are two holes, at the end of these holes there is a phillips (cross) gead screw, remove those and the armrest should come out.
Oldsmobile used 307s in those days, not 305s - the 307 had 140 hp
what type of refrigerant does a 1986 oldsmobile cuttlas suprem air conditioner require? reply to: email@example.com
only if they are both rear wheel drive or both front wheel drives
Bad battery, or the answer to most intermittent problems...bad ground.
what are the head tourque specs for a 1986 Oldsmobile calais 2.5 liter ?
It varies by engine.
Around 3500 lbs