answersLogoWhite
Headlights Tail and Brake Lights
Buick LeSabre
DIY Projects

How do you install the headlight assemblies for a 1989 Buick LeSabre?


Top Answer
User Avatar
Wiki User
2015-07-15 20:08:21
2015-07-15 20:08:21

Well, I have an 88 lesabre that i had a fender bender in last year. If its the same setup then there are 3 bolts on the top of the assembly that u can access when u open the hood, and the fourth bolt is behind the front grill. You may need to take the grill off to get to it but that only involves about 6 or 8 screws which u can see when looking from the front. There is also a spring at the back of the assembly that connects to the header panel, and 2 wiring harnesses to connect, one each for high and low beams.

Related Questions

User Avatar

Each headlight should have two (or three?) plastic clips that look somewhat like a six inch ruler holding it in. Pull the clips upward to release, then slide the headlamp assy. forward.

User Avatar

How do you install a heater core on a 1998 buick lesabre

User Avatar

You can access the headlight connector from the back of the headlight, in the engine compartment. Remove the headlight connector. Take hold of the light bulb, push in and turn at the same time. Reverse the process to install the new headlight light bulb.

User Avatar

Connect the wiring harness to the back of your 1995 Buick LeSabre stereo. Secure the stereo with the stereo retaining screws.

User Avatar

Remove the entire headlight assembly to gain access to the bulbs.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.