answersLogoWhite
notificationBell
Daewoo Leganza
Honda Accord EX

How do you install two lamps?

Be the first to answer!


Related Questions


two lamps in parallal will be brighter.AnswerIt depends entirely on the voltage/power ratings of the two lamps.



Go to www.stores.ebay.com/blinglightsracing or www.blinglights.net I have an 05 Ram and I purchased their kit, and had it installed within an hour. There fog lamps are twice as bright as factory fog lamps. I highly recommend them!


Take a look here, if your Ford is a MK2. http://www.fordmondeo.org/wiki/index.php/Fog_Lights_-_Mk2


NO. Two 60W lamps will use 120W - which is more than 100W !!


If a lamp burns out in parallel circuit, the other two lamps will continue to glow. If a lamp burns out in the series circuit, the other two lamps will also go out. If 3 lamps are in one series circuit, and one of them goes out, the loop is disconnected.



Pottery Barn offers wide variety of lighting. Ceiling lamps, table and task lamps, floor lamps, bath lamps, outdoor lamps and decorative lamps are among them.


The overhead lamps on most LXI models do not illuminate due to the fact that there are two additional lamps that are optional on the door panels. If these door lamps are present, the overhead lamps are not wired to come on with the doors open.


There are two types of lamps the tungsten halogen lamps and incandescent lamps. Tungsten Halogen Lamps are similar to incandescent lamps and produce light in the same manner from a tungsten filament; however the bulb contains a halogen gas (bromine or iodine) which is active in controlling tungsten evaporation, whereas the incandescent lamp suppresses tungsten evaporation.


gas lampskerosene lampswhale oil lampsetc.


http://www.sx4club.com/forums/showthread.php?t=1097 the following website gives complete instructions


No, ordinary fluorescent lamps won't work with a dimmer. You have to install special bulbs and fixtures that are designed to be dimmed.


The type of lamps that were used were oil lamps, and candle lamps.


1. Solar lamps work with solar panels that absorb energy and store it in a battery2. Solar lamps, unlike other lamps, do not need electricity, but they must be placed in an area that gets at least 4 hours of direct sun per day3. Solar lamps are used in USA primarily for cost-effective, easy to install landscaping. In many third world countries, solar lamps are increasingly being donated to people who have not access to electricity to replace kerosene lamps. This helps prevents fires and carbon monoxide poisoning.


-- Connect the cells in series. The two terminals of their series combination present a potential difference of 4 volts. -- Connect both lamps in parallel between the terminals of the series-connected cells.


You can't. All you can do is install a new fixture that will allow higher wattage lamps.


The wiring schematic is printed on the label of the ballast. Just make the connections the same as what is shown and the lamps will work.


Two amber clearance lights a the top one on each side. On the rear you have to have two red clearance lights at the top, two red tail lamps, two red stop lamps and two red reflectors one of each on each side, electric turn signal lamps, amber to red, one on each side and one white license plate lamp.


The tip of a sharpened pencil; the pencil-sharpener; some lamps.The tip of a sharpened pencil; the pencil-sharpener; some lamps.The tip of a sharpened pencil; the pencil-sharpener; some lamps.The tip of a sharpened pencil; the pencil-sharpener; some lamps.


Candles. kerosine lamps, gas lamps were popular in cities


Paul Revere lit two lamps in the North Church to warn the citizens that the British were coming.


Whale oil lamps are lamps from the 1800s that were lit with whale oil. (: Whale oil lamps are lamps from the 1800s lit by whale oil. who ever wrote that sucks


Most light in America is provided by electric lights not oil lamps. However there are two types of oil lamps still sometimes used (mainly for decorative purposes): chimney lamps and tiki torches. Chimney lamps use a highly purified odorless kerosene type oil. Tiki torches use a nonspecific petroleum distillate oil.


I agree! You can just purchase a pair of OEM fogs that are on the '05/'06 Q45 and install them into the two holes in the front of the bumper. The fit will be snug, but comes out looking very uniform and factory. You can just wire the lights to work with your parking, headlights, or just install an on/off switch.