One sign is if you place you foot on the brake pedal and apply steady pressure, and the pedal slowing goes down toward the floor, the master cylinder is bad. As this car is 9 years old, when replacing the master cylinder, replace all the brake fluid in the entire system with fresh fluid from an unopened can. 1. It could have a leak at the master cylender. 2. the brake peddle slowly goes all the way to the floor.
Either the clutch master cylinder or the clutch slave cylinder or the clutch hydraulic lines are leaking.
it should be behind the cowel on the drivers side above the master brake cylinder.
The booster is on the driverside fire wall and the MASTER CYLINDER IS BOLTED TO IT.
You do not reset a master cylinder. You should bench bleed it before installing.
Put a new master cylinder on. Throw the old one away.
In the fuel tank
If the master cylinder reservoir is empty, you have a leak somewhere. If the master cylinder reservoir is full, the master cylinder is bad.
a bad wiper control module, its the box located on the firewall above/next to the master brake cylinder.
You have a vacuum line disconnected or broken under the hood, check in the area around the master cylinder and the vacuum reservoir.
Under the brake master cylinder.
Leak in master cylinder? Leak in slave cylinder? Leak in tubing from master to slave cylinders?
You will need to remove the door panel of your 1997 Chevrolet Corvette. When the door panel is removed the mirror retaining bolts will be visible. Tighten the mirror retaining bolts.
One for each cylinder.
Mounted to the firewall on the driver's side.
Doesn't have a bleeder valve on the master. You have to bleed the brake system at the wheels.
Two per cylinder, for a total of sixteen.
The clutch fluid reservoir is located on the firewall close to the brake master cylinder. You can visually see the level unless the reservoir is to dirty.
disconnect the hose from the clutch master cylinder on the firewall. I has a little retaining pin in it use a nail or something small to push it out then you can drop the tranny with a 4 foot line connected to it once you see the slave cylinder you can disconnect the hose the same way the hose was connected to the clutch master cylinder I learned this when I had to replance my slave cylinder
i have a 1997 chevy cavalier the wipers and radio work when turn the key swich back
The clutch release ("throw-out") bearing has gone bad...Use a new clutch disc when you replace the clutch release bearing...or it could be the clutch master cylinder. Check the master cylinder first...Look for any sign of leakage from either component .
Just to the front and side of the brake master cylinder
in the distrubutor i believe
Below the brake master cylinder and to the left (drivers side) of the vehicle.
the dipstick is located between the brake master cylinder and the valve cover.