Remove and replace the fuses one at a time whilst pressing the brake peddle until the lights go out.
Have an electrician check the wiring that goes to the brake lights in the trunk of the car.
I have no lights and I can't figer out what fuse goes where I need a diagram of fuse box
The fuse box diagram is the diagram on the back panel of the fuse box cover. It shows what each fuse and relay goes to, and what it helps.
This can get complicated OK check your brake light switch (it is under the dash look under dash at the brake pedal look for a switch the goes that switch when you push the brake pedal there may be more than one) use a 12 volt test light or meter to see if the switch has 12 volts and is working. If not replace if so next you may want a wiring diagram a lot of time the hazard switch goes bad or the wiring in the column goes bad. From the fuse panel to the brake light switch and to the hazard is a orange wire make sure has 12 volts at all times if not that's the problem. from the brake light switch the wire is white and goes to the hazard assy. . the orange wire also goes to the hazard switch then comes out the hazard switch brown and goes to the hazard assy. . coming out the hazard assy the right brake light wire is dark green and the left wire is yellow.
hold the diagram upright there should be a flasher use this as a referance point
Fuse nineteen goes to the fog lights. The fuse box as well as the manual should have a diagram of the fuse box.
A fuse box diagram helps the driver know which fuse goes to what car part. The diagram for a 1991 Ford Ranger is in the owners manual or on the inside fuse box cover.
A blow 15 amp fuse in the under dash fuse panel causes that i think it is fuse # 24, goes to csmt or something like that
should be the tail lights fuse
Not enough info to answer. Please ask a new question and include the year, make, and model of the vehicle in question.
i need a fuse box diagram for a 2000 Lincoln Continental....my gratitude goes out to anyone who can help me. THanks
A fuse diagram for the 2005 Dodge SXT van can be purchased at your local auto parts store. What each fuse goes to, is typically listed on the fuse box cover lid.
In my 1989 Dodge Dakota the brake light is on fuse number13 it is a 5amp it also goes to buzzer, speed control, check engine light, anti-lock warning light, and other things page 12-19 Haynes 1987- 1993 Dodge Dakota Repair Manual
There is a fuse and when that fuse shorts out the light willl go on and off. There is a fuse and when that fuse shorts out the light willl go on and off.
Have the same problem with '95 Integra; horn and stop light fuse goes repeatedly Checking the brake lights sockets wiring, hoping its there then the switch on the brake pedal then (groan) start looking at the internal wiring
Where the fuse box is, remove the panel and there should be a sticker on it, that shows what goes where, and what amp the fuse is.
When you pop the pannel off to access the Fuses there will be a sticker on that pannel with what fuse goes where and how many Amps that fuse needs to be.
Assuming you mean the red " BRAKE " light in your dash is lit : That means that either your BRAKE FLUID LEVEL IS LOW in the brake master cylinder or your parking / emergency brake is engaged
Vauxhall Corsa fuse numbers can be seen on the fuse box. The underside of the fuse box will have a diagram explaining each slot and what fuse goes where.
depends what it's on. You can just look on the fuse panel cover or on the fuse holder, it will have everything labeled with abbreviations or numbers corresponding to the cover.
you need a new brake pressure differential switch
When changing fuses it is important to know which fuses goes to what part. The owners manual has a free fuse diagram, and there are usually diagrams on the back panel cover or the inside the fuse box lid.
Maybe is the fluid brake that is low level.
You really don't need it. You just need to identify which harness goes from the ECM to the jake brake.