It does not have a 3-4 shift solenoid. It has a 1-2 and 2-3 only. What you are calling 4 is overdrive, no solenoid.
Type your answer here... NO. The 95 MUST have the 4L60E transmission put BACK in it if it is a 1/2 ton. If it is a 3/4 ton then it MUST have the 4L80E trans. put in it. If you put the 91 transmission in it then the engine will not run right and the transmission won't shift.
Yes it will fit, but it won't work... The 89 computer is not programed to the 4L60E transmission, Therefore the transmission will not shift are even work.
It is bolted to the valve body in the bottom of the Transmission. Need to remove trans pan to service them.
The computer (ECM).
Blown fuse. Solenoid failure. Damaged wiring.
in the transmission, you have to drop the pan .
on the right side of the transmission above the pan is an electrical connector on the 4L60E and on the 700R4 there is a cable. this cable is the downshift cable which controls shift points which are electronic on the 4L60E
Answerthe vehicle speed sensor can cause this problem or it can be the thermostat.i had the same problem and it worked for me.
yes
The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.
NO You can not. The compurter and wreing harness in the 1990 will not hook up are even shift the 4L60E transmission. You MUST put the 700R4 back in it.
physically it will fit but the wire harness and computer are not compatible.