Hey Jeff==It is on the pass side of the intake manifold. There should be a hose going from it to the throtle body. GoodluckJoe
Additionally: I rotated my engine to get access to the pcv, and changed the three sparkplugs back there while I had access. Using the slope of the driveway as a helper, I was able to swing the engine just by grabbing the top and pulling it toward me. Jonny
the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.
The PCV valve on a 1994 Regal Custom should be located on top of the valve cover. It is a plug in type and is easily changed.
Freon valve on my 1989 Buick Regal Custom 3.1 V-6 located on driver side under the area of battery tray. Hope this helps!
Where is the heater control valve on a 1994 Buick Regal
On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.
the pcv should be near the front valve cover
The PCV valve for a 1999 Regal 3.8 is located on the top of the valve cover. The valve pulls out to replace it.
Front (belt side), top of motor. it is covered by a plate with 3 bolts holding it on. Careful, it is spring loaded.
The PCV valve for a 2001 Buick LeSabre is located in the top of one of the valve covers. It is a plug in unit and is easily changed.
How to fix heater in Buick there is cool air ,fan is work .but no warm air
it is on the throttle body. usually held in by two screws.
At the top of the engine near the firewall and directly behind the carburetor.
It is bolted to the side of the cylinder head closest to passenger compartment on driver's side.
Driver's side valve cover top, locate 3/4" hose its on the end that is inserted into the valve cover.
Hey Andre==You don[t say which side but just get everything out of the way, remove the screws and take the valve cover off.
Remove the float from the Regal. inspect the float for leaks, then check the spring and needle valve as it could be stuck. If all parts are ok then the parts need cleaning as they are sticking.
may be your heater control valve
Perhaps a vacuum leak check power brake booster and check valve at booster
Look for the port(s) on the ac lines. they work like a tire valve. Should be a round blue thing.
Remove each valve cover (four bolts.) Remove the gasket and set a new one in place. Set the valve cover in place and tighten the bolts to spec.
i just had it done. it s in the middle of the motor. up against the fire wall. cant miss it
remove motor mount "dog bones" and also label/remove spark plug wires from spark plugs, remove valve cover, clean cover from debris, use light coat of oil to stick gasket, replace round rubber gaskets, replace cover, wires and "dog bones"
I had the same thing happen to my car that code means insufficent egr flow. You have to replace the egr valve.
where dose a pcv valve go no 1996 buick lasaber...
Locate pcv valve on 1995 ford contour