most of the time, it is on the drivers side behind the lower panel.
be carefull, removing the aftermarket module can make the car not start, as they may have tapped into the ignition circuit.... check all the WIRING going to their alarm module, and see if they have changed any of the original harness... good luck :)
To disable the seat belt alarm on a Chevy Colorado, locate the alarm fuse. Pull out the fuse to disable the alarm.
cant by pass the alarm system...
Read the instructions that came with the aftermarket alarm and follow them.
the aftermarket alarm kit
When the LED light on an aftermarket alarm stays on, it means that the alarm is active. The light generally shows that the alarm status is "ready."
the remote has been lost and a new remote has been purchased. i had to remove the fuse to get the alarm to stop. how can i reset the alarm? So i can program the new remote.
How do you Reset the alarm on a 1998 Camaro Z28? If I set the alarm it will go off moments later. I was hoping a reset would fix this issue.
Well I take it that this is an aftermarket alarm system. If you do not plan on using the alarm anymore and just want your vehicle to start then go under the dash and locate the wires comming out of the ignition cylinder. Then find a black wire with a white stripe and follow it until it gets cut and taped into the aftermarket alarm. Now cut away the aftermarket alarm wires and attach the two ends of the black/white wire back up together again
If the alarm is aftermarket, cut the power wire. If the alarm is factory, buy a new remote.
No you purchase an aftermarket one
no