Auto Parts and Repairs
Fuel Filters
Chevy Metro
Geo Metro

How do you locate the oxygen sensor on a late-model Geo Metro?

353637

Top Answer
User Avatar
Wiki User
2015-07-15 19:31:11
2015-07-15 19:31:11

Look on either the exhaust manifold or exhaust pipe.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It is possible as the signal from the oxygen sensor is sent to the computer

User Avatar

you gotta take the old one out first

User Avatar

I have a 99 Metro 1.3L. This car has two oxygen sensors, one in the exhaust manifold and the other is after the Catalytic Converter. Hope that helps.

User Avatar

They are blue, black and white. They can be found extending from the catalytic converter (the upstream O2 sensor) and possibly from a second source (the downstream sensor).

User Avatar

It has 1 O2 sensor located on the exhaust manifold befor the catalytic converter

User Avatar

to change o2 sensor ,you need to buy a o2 sensor socket from a parts store then disconnect neg terminal on battery ,after that disconnect wire connecter on o2 sensor and remome o2 sensor

User Avatar

in the exhaust pipe right under the manifold it is easy to get to right in front under the hood

User Avatar

I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.

User Avatar

that must be some metro to have a big block

User Avatar

The closer to th engine is upstream and the farther is downstream Before the cat upstream After the cat downstream.

User Avatar

You can locate the transmission fluid leak on your 2001 Chevy Metro by looking at the transmission fluid on the ground. Look above the transmission fluid stain and you should be able to see the source of the leak.

User Avatar

Nope, on the 94 models, there is only one and it's either in your exhaust manifold or in the exhaust pipe. In 95 they started putting 2 in them.

User Avatar

connected to the air cleaner housing

User Avatar

LOL, some dont have crank sensors my friend! if you dont have a crank sensor by your oil pan then you have a bad distributor sensor!

User Avatar

O2 sensor CKT No Activity (Bank 1 Sensor 1)

User Avatar

on a 3 cyl.metro,the iat sensor is found on the air cleaner housing towards the rear of the assembly

User Avatar

If they are the same sensor... replace the easy one first and if the code returns, take the old one and replace the other one

User Avatar

there are two 02 sensors on a 97 they are easy to replace,i have seen these sensors for around 90$ which is high for an 02 sensor but can easily be done yourself, if you can find a low mileage one in a junk yard you could do it for a few dollars

User Avatar

In front of and behind the catalytic converter.

User Avatar

NO cable. it has a vehicle speed sensor bolted into the transmission. Electronic controlled.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.