answersLogoWhite

0


Best Answer
Copy

It is located on the bell housing between the engine and transmission.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:28:37
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you locate the starter in a 1996 Mazda Protege?
Write your answer...
Submit

Related Questions

Where is the EGR valve on a 1996 Mazda Protege?

Where is the EGR Valve on a 1996 Mazda Protege located at?


Where is the starter for Mazda Protege 1996?

It is on the firewall side of the engine about half way up and a real beast to get at.


Where is the horn relay on a 1996 Mazda Protege?

where is located the relay of the horn of mazda protégé 1996


Inertia switch 1996 Mazda protoge?

was wondering where the inertia switch is on a 1996 Mazda protege


Po170 fuel trim malfunction bank1 1996 Mazda Protege?

po 170 fuel trim malfunction bank 1for 1996 Mazda protege


How do you set the ignition timing for a 1996 Mazda Protege and what is the correct timing?

Hoo I set the correct timing on a 1993 mazda protege


Where is the fuel filter located on a 1996 Mazda b2300?

Where exactly it the fuel filter located on my 1996 Mazda protege 1.5 motor.


Where is the fuel filter located in a 1996 Mazda Protege ES?

there isn't one


Why is 1996 Mazda Protege blinkers not working?

Check the polarity of the etho port


How do you replace a cigarette lighter in a 1996 Mazda Protege?

Take it out and put in a new one.......


How do you change the fuel filter on a 1996 Mazda Protege?

what has to be removed to get to fuel filter


Where is the oil filter located on a 1996 Mazda Protege 1.5 liter?

It is above the oil pan.


Where is the PCM located in a Mazda Protege 1996?

Under the console directly under radio and hvac controls


How do you remove the hub nut from 1996 Mazda Protege?

36 mm socket and a long ratchet or bar.


Where is the starter on a 1996 Mazda B3000 located and how do you change it?

The starter on a 1996 Mazda B3000 is located near the battery terminal. To change it, first unbolt the negative cable from the battery terminal and raise the right front corner of the Mazda B3000 with a jack. Unbolt the starter wiring and thread the mounting bolts through the starter. Finally, reconnect the starter wiring.


Manual transmission fluid capacity 1996 Mazda dx?

Mazda dx what? Protege, 626, B-truck?? Protege capacity would be 2.83 quarts or 2.68 liters. Mazda 626 manual trans would take 2.9 quarts or 2.7 liters.


To change the starter on a 1996 Mazda Protege would you go from the top of the engine or from under the car?

From the top side you would remove the top bolt. From under the car, remove the bottom two bolts and disconnect the wires.


What is the spark plug gap for a 1996 Mazda Protege Lx with one point five liter engine?

.044


How do you find the starter on a 1996 Mazda 626?

the starter is in the front of the engine on the bottom,on the 4 cylinder.follow the cable from the battery +.


How do you change the alternator belt in a 1996 Mazda protege?

What bolts to loosen to put alernator belt on and how to put it on when a/c belt is on.


Where is the horn in a 1996 Mazda Protege?

Just behind the right corner of the front bumper. You have to remove the black cover under the car to see it. Mazda hide it pretty well.


Where is the starter on 1996 Mazda 626?

in a v6 its in between the motor and the firewall in the drivers side.


What causes error code p0400 in Mazda 1996 protege?

Trouble code P0400 means:Exhaust gas recirculation-flow malfunction


Where is the speed sensor on a Mazda protege?

i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).


Why does your 1996 Mazda protege die when you take your foot off the gas it also wont idle?

Try the idle air control motor