If it is a 1.5 volt bulb you can connect it through a series circuit directly to your battery.
If the bulb is not made to run on 1.5 volts and needs another voltage, it may not light up!
If you place an end of a wire on the negative or positive side, put the outer metal part of the light bulb's cap on the other, and place the other end of the wire on the light bulb's cap's inner metal part, it will turn on.TipBefore you try to do this, always check that the voltage of the battery is equal to, or a bit less than, the voltage of the light bulb!Otherwise the light bulb may only give out a very bright flash and could easily be destroyed.
Thomas Edison is quoted as saying "I did not fail, I found 2000 ways how to not make a light bulb." He did finally succeed in finding the one way to make a light bulb.
Thomas did NOT make the light bulb. He made a safer impression of it.
Thomas Edison was credited to make the light bulb.
187 light bulb atemps
no it will bloww
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
no. it cant make its connection so it wont make any light.
You need a Battery, Light Bulb, Ammeter, Switch.
The things you need for your curcuit are: A light bulb, Bell wire, A Battery and a conducter ex. pin, paper clip Attach the bulb together with the battery using the bell wire. With the two ends of the wire connect to the conducter and see if light bulb comes on.
you can make the light bulb turn on. Ooh ooh i know. it's a circuit!
If you connect the circuit properly the bulb should light up. That means attaching the left side of the battery to the right side of the bulb using a wire and attaching the right side of the battery to the left side of the bulb. If you do that the your bulb should turn on. If it doesn't then try changing the battery or the bulb.
The flow of electrons from the battery flow through the filament in the bulb causing it to get hot and glow thus producing light.
You need a Battery, Light Bulb, Ammeter, Switch.
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
Yes it is possible to make an acid battery using the acid in a lemon. (you would need allot of lemon batteries to light a flashlight bulb though - try using a diode light bulb) For more information on how to do this look in the link I will place below.
Get your bulb, it should be a very small wattage (weak) one, get your battery and wires, connect one wire to plus side of abttery and other wire to minus side of battery, then connect to the bulb, you may have to play around a bit to find a connection that produces light.