place the centre of the protractor on the vertex Y of angle XYZ. Let the reference line of the protractor coincide with ray YZ of the angle. Find the 'zero' mark on the reference line of the protractor that coincides with ray YZ. Observe the markings that increase serially from the 0 that is near point Z.
One of the two scales goes UP from 0 to 180, the other goes DOWN from 180 to 0. You use the scale woThe angle made by the base line is 0 so you use thehich shows 0 degrees for the base line of the angle. The base line is the one that was lined up with the protractor's diameter.
There is no way to draw a triangle using a protractor that cannot be done more simply using only a straightedge.
However, you can make an equilateral triangle by first drawing a straight line, measuring a 60 degree angle from each end, and drawing two more lines until they meet.
well i think you should try and think it out and if that does not work well try a paper that works for me well i am sorry if it does not work but you can try it
You hold it like a "D" with the curved part facing upwards. Rotate the D 90 degrees to the left
turst please
-dan
a protractor is used to measure an angle
with a protractor
With a protractor
With a protractor
Place the center point of the protractor at the vertex of the angle and one of the lines of the angle along the zero line of the protractor. The measure of the angle will then be where on the protractor's angular scale the other line of the angle lies.
A protractor is used to measure an angle.
A protractor can be used to measure an angle.
To measure ans angle, put the hole on the the vertex, line up the protractor with the angle and look at the degrees.
A protractor
With a protractor
Use a protractor.
you will go to north protractor it means 0 and count up to the line of the angle example: