Installing this part in a 1998 GMC Safari or Chevy Astro requires enlarging the hole in the duct where the resistor is mounted. I did this using a utility knife with a new blade installed. I don't think that it is possible to safely modify the resistor module to fit in the hole provided when the vehicle was manufactured.
The blower motor resistor on a 1996 Safari Van is located on the blower motor. The blower motor is on the fire wall inside the engine compartment on the passenger side.
You need to replace the blower motor resistor. I've been there done that.
The high-speed relay is part of the blower resistor board, mounted in the air duct behind the coolant/washer bottles. Follow the wires from the blower motor, they lead to the resistor connector block that the blower resistor board is plugged into.
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
The blower resistor has failed.The blower resistor has failed.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
your blower motor resistor is probably bad....it shoul dbe replaced.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed
resistor for fan blower is in back of glove box, beside the blower itself.